How to Legally Drive a Widebody Modified Car?

What causes the abnormal noise when turning the steering wheel of the Volkswagen Sharan?

The reasons for abnormal noise when turning the steering wheel of the Volkswagen Sharan include friction sounds, tire scrubbing noise, and excessive wear of the half-shaft CV joint. The following are specific details: Abnormal noise when turning the steering wheel while parked: It is likely the sound of the horn wire transmission spring steel plate rubbing against the steering wheel. The noise usually comes from inside the car and is a rustling metal friction sound. The solution is to apply some lubricant at the contact point between the spring steel plate and the steering wheel. Abnormal noise when turning the steering wheel while driving:

12

3

Share

What type of batteries does BYD use?

BYD uses ternary lithium batteries and lithium iron phosphate batteries. Below is an introduction about these batteries: Battery advantages: Lithium iron phosphate batteries refer to lithium-ion batteries that use lithium iron phosphate as the cathode material. Their characteristics include the absence of precious elements such as cobalt, low raw material costs, and abundant resources of phosphorus and iron on Earth, ensuring no supply issues. They have a moderate working voltage (3.2V), high electrical capacity per unit weight (170mAh/g), high discharge power, fast charging capability, long cycle life, and high stability in high-temperature and high-heat environments. Battery disadvantages: The disadvantages are that lithium iron phosphate has some performance defects, such as low tap density and compaction density, resulting in lower energy density of lithium-ion batteries; high material preparation and battery manufacturing costs, low battery yield, and poor consistency; and poor product consistency.

10

3

Share

What transmission is used in the Haval H6 third generation?

Haval H6 third generation is equipped with a 7-speed wet dual-clutch transmission for automatic models. Transmission: The transmission is a gearbox that changes the transmission ratio and direction of motion. Located between the clutch and the central drive. Its main functions are to change the driving force and speed of the vehicle (shifting) while keeping the engine speed and torque unchanged; to enable the vehicle to reverse (direction change); and to allow the engine to idle without stalling (neutral gear). Haval H6 third generation models:

9

3

Share

What is the ECO mode in a car?

ECO is the fuel-saving mode in a car. Here are the relevant details: How the fuel-saving mode works: It analyzes various factors affecting fuel consumption, such as transmission gear position, engine speed, braking system, etc., through multiple sensors. The ECU then calculates the optimal fuel injection amount for the engine operation. When ECO mode is activated, it comprehensively evaluates and analyzes conditions that influence fuel consumption, including automatic transmission gear position, engine speed, vehicle speed, braking, and transmission oil temperature. The ECU control unit calculates the optimal fuel quantity to supply the engine, effectively reducing fuel consumption compared to normal driving mode. Advantages of the fuel-saving mode: It enhances the vehicle's fuel efficiency, with particularly noticeable effects for high-displacement cars. For family cars used in daily life, fuel consumption performance is also a key consideration.

12

1

Share

Where is the heat dissipation vent of the Audi A3 headlight located?

The heat dissipation vent of the Audi A3 headlight is located at the rear of the headlight. When the humidity is high and there is a significant temperature difference between the inside and outside of the headlight, a small amount of fog may form on the inner wall of the headlight cover, which usually disappears automatically after the headlight has been on for a while. The function of the headlight heat dissipation vent: In terms of the overall structure of the headlight, whether it is a conventional halogen headlight, a xenon headlight, or a headlight with LED light groups, there is a ventilation rubber tube at the position of the rear cover. When the headlight is turned on and during its use, a large amount of heat is generated. The function of the ventilation tube is to discharge this heat as much as possible outside the headlight to maintain the normal working temperature of the headlight and ensure its stable operation. The downside of the heat dissipation vent:

10

1

Share

Can a Car Engine Run Without Engine Oil?

It is recommended not to continue driving if the engine is low on oil. Below is an introduction to the functions of engine oil: Lubrication: There is rapid relative sliding between the piston and cylinder, as well as between the main shaft and bearing bush. To prevent excessive wear of parts, an oil film needs to be established between the two sliding surfaces. A sufficiently thick oil film separates the surfaces of the relatively sliding parts, thereby reducing wear. Auxiliary Cooling: Engine oil has a relatively low specific heat value and, being inside the engine, does not inherently have a cooling effect. However, during engine operation, the heat generated by fuel combustion can be carried back to the oil tank by the engine oil and then dissipated into the air, assisting the radiator in cooling the engine. The actual cooling is performed by the water (or antifreeze liquid) outside the engine casing.

18

4

Share

How to Legally Drive a Widebody Modified Car?

What causes the abnormal noise when turning the steering wheel of the Volkswagen Sharan?

What type of batteries does BYD use?

What transmission is used in the Haval H6 third generation?

What is the ECO mode in a car?

Where is the heat dissipation vent of the Audi A3 headlight located?

Can a Car Engine Run Without Engine Oil?

What do the letters and numbers on spark plugs represent?

Where are the drainage outlets of the Bestune X40 located?

What are the maintenance items for the Passat at 10,000 kilometers?

What causes the Jetta to report a camshaft position signal too small?