How to Install the Dash Cam on Geely Boyue?
3 Answers
Geely Boyue dash cam installation steps are as follows: 1. The Boyue dash cam directly draws power from the cigarette lighter socket. It is recommended to install it on the car's original rearview mirror to ensure interior aesthetics. 2. Tuck the wires along the headliner, route the power cable and GPS cable down the A-pillar, stick the GPS module in a corner of the dashboard, and install the GPS signal receiver. 3. Alternatively, you can open the right cover of the instrument panel to fix the GPS module, then route the power cable along the underside of the glove compartment to the car's power socket and plug it in. The dash cam installation is now complete.
Last time I installed a dash cam on my Geely Boyue, the whole process was simple and fun. First, choose a adhesive mount to fix it beside the rearview mirror at the top of the windshield, ensuring it's centered and doesn't obstruct the view. Then route the power cable: gently pry open the gap along the edge of the headliner, slowly tuck it along the A-pillar, pull it all the way down below the glove box, and finally plug it into the cigarette lighter socket. Remember to use a plastic pry tool to avoid scratching the interior. After installation, adjust the lens to face the road ahead and test the recording to ensure it's clear and unobstructed. DIY saved me about 200 yuan in installation fees, and now I drive with more peace of mind in case of disputes. Beginners are advised to start with a tool kit bought online and avoid the high-risk fuse box. Pay attention to neat wiring for a clean and tidy interior. The whole process took half an hour and was very rewarding—highly recommend giving it a try.
For frequent car enthusiasts, installing a dash cam is straightforward: First, position the camera near the top of the windshield on the inside and secure it firmly using the included suction cup. Next, route the wiring along the headliner, down the A-pillar, and tuck it into the interior trim to prevent looseness and rattling, then guide it to the glove compartment to connect to the cigarette lighter power source. Use a small pry tool to gently tuck the wires without excessive pulling. During testing, start the vehicle to confirm the recording angle avoids direct sunlight. The key is to hide all wiring for safety and aesthetics. If it feels complicated, refer to video tutorials for assistance, but avoid connecting to the fuse box unless you're knowledgeable about circuits. Beginners are advised to prioritize the cigarette lighter method—it takes about half an hour, is low-cost, and enhances driving protection.
