How to Deal with Nervousness During the Driving Test (Subject Three)? How to Eliminate Nervousness?

1 Answers
DeElena
07/25/25 4:39am
Before the test, it is essential to eliminate distractions and keep your mind in a "blank" state. Use self-suggestion methods to divert your nervous emotions. If you feel overly nervous or physically uncomfortable when entering the test site, you can consciously relax yourself psychologically.
Was this review help?
14
2
Share
More Forum Discussions

How to Install a Car Mount?

Clean the desired mounting location with an alcohol wipe. Peel off the 3M adhesive on the base of the mount and attach it to the cleaned area. Place the magnetic plate on the mount base and attach the metal plate to the back of your phone. Adjust the angle by placing your phone on the magnetic disk.
8
2
Share

What to Do When the Door Cable Is Broken and Won't Open?

First, try using the car key to unlock and then lock the door, repeating this process twice; Then locate the central locking button on the left front door trim panel of the driver's compartment, press the unlock button, and try opening the door again.
9
0
Share

How to Adjust the Brightness of the Car Display Screen?

Use the adjustment wheel on the left front panel of the driver's cabin to adjust the brightness of the dashboard and central control screen. Press the wheel button on the left front side of the cockpit to adjust the headlight height. To turn off the screen, you can start and then turn off the engine while sitting in the car, open and then close the driver's door. At this point, the main screen will turn off, and the dashboard will also turn off after a while.
18
4
Share

How to Restore Sound After Car Goes Silent?

Locate the volume adjustment knob in the center console of the vehicle; rotate the switch knob to the right and adjust it to the maximum; Press the voice control button on the right side of the multifunction steering wheel and hold it for five seconds; Press the vehicle's one-touch start button to turn off the engine, then press the button again to start the engine. At this point, the vehicle's sound will be restored.
19
3
Share

What is the procedure for replacing a driver's license at the DMV?

Motor vehicle drivers should bring the required materials to the vehicle management office where the driver's license was originally issued to apply for a replacement. The vehicle management office will process the replacement within one working day after approval. Materials required for replacement: Bring two copies of ID card, two 1-inch color passport photos without a hat, original ID card, original driver's license, and a medical examination certificate from a county-level or above hospital (free physical examination is also available at the DMV). The replacement and inspection must meet the following conditions: Holders of large passenger vehicle, tractor, city bus, medium passenger vehicle, or large truck driver's licenses have no points in the current scoring cycle, or holders of other driver's licenses have less than 12 points in the current scoring cycle; Holders of large passenger vehicle, tractor, city bus, medium passenger vehicle, or large truck driver's licenses who have points in the current scoring cycle, as well as holders of other driver's licenses who have caused a traffic accident resulting in death and bear equal or greater responsibility but have not had their driver's license revoked, and have participated in the inspection education; The applicant has no pending road traffic safety violations or traffic accidents; The applicant's physical condition meets the driving license requirements; The driver's license is not legally seized, detained, suspended, revoked, canceled, or rescinded.
15
4
Share

What to Do When the Nissan Sylphy's Battery is Dead and Won't Start

Need to bring the two cars as close together as possible. Generally, the car battery is located under the front hood. The two cars should be parked side by side or head to head. Next, locate the batteries of both cars, identify the positive and negative terminals, remove the terminal covers, and use the red battery cable clamp to attach to the positive terminal. Then, attach the red clamp first, followed by the black one. Once all four terminals are connected, the jump-start setup is complete, and you can proceed to start the car with the dead battery.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.