How to Deal with a Faulty Tire Pressure Monitoring Display in a Haval Vehicle?

1 Answers
HavenMarie
07/30/25 5:44am
First, get out of the car and check to confirm that the tire condition is normal with no air leakage. Pull out the key and reinsert it to start the car. If the tire pressure monitoring still does not appear, you can start the car and drive at low speed for about five to six minutes, and in most cases, the tire pressure will be displayed. Remove the negative terminal of the car battery for a few minutes and then reattach it. After inserting the key and resetting the central control, the display should return to normal. If the car has been through water and the tires have taken in water, it may cause the tire pressure monitor's battery to short-circuit and fail to supply power properly. Cleaning it thoroughly can resolve the issue. If the battery is dead, replacing it will solve the problem.
Was this review help?
8
4
Share
More Forum Discussions

What are the reasons for turbocharger failure?

The reasons for turbocharger failure are as follows: 1. Using unqualified engine oil. Engines with turbochargers must use high-quality synthetic oil. Using unqualified oil can lead to carbon deposits and sludge, which may severely clog the oil passages, resulting in poor lubrication of the turbocharger. 2. Using oil containing impurities can cause serious damage to the turbocharger. When the oil filter is clogged, the bypass valve opens, allowing unfiltered oil to circulate. Oil with impurities causes much more severe wear and damage to the turbocharger bearings compared to engine bearings, as the turbocharger operates at much higher speeds than the engine. 3. Delayed maintenance leading to oil oxidation and deterioration. After prolonged use, various oil additives degrade, causing oxidation and deterioration, which damages the oil lubricating film.
3
5
Share

How Many Years Does a Car Water Pump Generally Last?

Under normal usage conditions, the lifespan of a car water pump is typically 8-10 years. Here is the relevant content introduction: The working principle of a car water pump is that the engine drives the water pump bearing and impeller through a pulley, causing the coolant in the water pump to rotate along with the impeller. Under the action of centrifugal force, the coolant is thrown to the edge of the water pump housing, generating a certain pressure, and then flows out through the outlet channel or pipe. Due to the coolant being thrown out, the pressure at the center of the impeller decreases, and the coolant in the radiator is sucked into the impeller through the pipe under the pressure difference between the water pump inlet and the center of the impeller, achieving the reciprocating circulation of the coolant.
8
3
Share

How to Replace the Key Battery for Mazda?

Mazda car key battery replacement steps are: 1. Pull out the mechanical key inserted in the key. 2. Pry open the gap on the side of the key. 3. Open the key cover and replace the old battery. Mazda is a Japanese automobile manufacturer, with main models including: Mazda3, Mazda5, Mazda6, etc. Below is an introduction to Mazda's main models: 1. Mazda3: A high-performance sedan that adheres to Mazda's consistent design philosophy of 'technology-oriented Mazda,' fully embodying the brand's connotations of fashion, creativity, and vitality. Its handling performance inherits the essence of the Mazda brand. 2. Mazda5: The exterior design follows Mazda's sporty and robust style, featuring a relatively elongated body, a signature flat inverted triangle grille design, sharp combination headlights, and body lines that give a feel akin to a galloping horse. The sliding rail at the rear of the car is distinctive, with sliding doors that facilitate easy entry and exit, offering a solid yet not heavy push feel. 3. Mazda6: The exterior design is stylish, paired with vibrant colors that cater to the tastes of younger consumers. The streamlined body design aligns with its coupe style. The 2.3L DOHC engine is made entirely of aluminum alloy, which reduces the vehicle's weight, thereby improving fuel economy.
13
3
Share

What does the yellow exclamation mark in CRV mean?

The appearance of an exclamation mark on the car dashboard indicates an abnormality or malfunction in the system. There are many indicator lights on the car dashboard with exclamation marks, such as the tire pressure indicator light, lighting fault indicator light, steering system fault indicator light, brake system fault light, transmission fault indicator light, and wiper fault indicator light. Below is a detailed introduction to the exclamation mark warning lights: General Fault: A triangle with an exclamation mark inside indicates that the car's general performance, components, or functions have malfunctioned. This mainly includes parking sensor failure, fuel cut-off system intervention or failure, external light failure, engine oil pressure sensor failure, etc. It is necessary to go to a 4S shop for inspection to identify the source of the fault. Automatic Transmission Fault: A yellow gear with an exclamation mark inside is the automatic transmission fault warning light, indicating that there is a fault in the transmission or the transmission lubricant is below the normal range. The transmission oil should be replaced in time. Brake System Fault: An exclamation mark inside a circle with parentheses represents a warning for the brake system, mainly indicating a brake system failure or low brake fluid level. The brake system should be inspected immediately to avoid accidents. Tire Pressure Abnormality: An exclamation mark with a horizontal line below the parentheses represents the tire pressure monitoring warning light. This light will illuminate when the car's tire pressure is too low. Check the car's tire pressure and restore it to the normal range. Lighting Fault: A yellow bulb with an exclamation mark is the lighting fault indicator light, indicating that a car light has malfunctioned. Solution: Go to a 4S shop for inspection as soon as possible, or check it yourself, focusing on commonly used bulbs such as turn signals, fog lights, and interior lights to identify the problem. In addition, during the daily use of the vehicle, the fault lights displayed on the vehicle dashboard are divided into two different colors, yellow and red: Yellow indicates that there is a fault in the corresponding system, but the problem is not very serious. Reduce speed and proceed to the corresponding repair point for maintenance to eliminate potential safety hazards in time. Red indicates that there is a very serious problem in the corresponding system. In this case, do not continue driving. Pull over immediately and call for professional help to prevent unpredictable dangers to the vehicle and personal safety from forced driving. It should be noted that when the car is started, all lights will turn on, and the system will perform an automatic check. After the check is completed, the lights will automatically turn off. If a light does not turn on or remains on when the ignition is turned on, or if it lights up while driving, it indicates a fault in the related system. In such cases, seek professional help promptly for car inspection to eliminate potential safety hazards.
10
5
Share

What are the characteristics and problems of flood-damaged cars?

Flood-damaged cars have the following characteristics and issues: Pungent odor inside the car: If the interior has been submerged in water, it will emit a persistent musty smell that is hard to eliminate. Therefore, check both front and rear areas of the car for any lingering odor. However, after the vehicle has been cleaned and detailed, this is usually difficult to detect. Alternatively, you can pull the seatbelt all the way out to check for residual mud or sand. Rust on interior brackets: There are many exposed metal brackets beneath the dashboard. Since these brackets are not easily exposed to moisture, manufacturers generally do not apply anti-rust treatment to them. When water enters the car, the evaporation of moisture will cause these brackets to rust.
9
5
Share

What is the difference between 95 and 98 gasoline for Mercedes-Benz E300?

The biggest difference between 95 and 98 gasoline lies in the amount of isooctane they contain and their anti-knock properties. The Mercedes-Benz E300 requires the use of 95 gasoline, but 98 gasoline can also be used. Below are the relevant details: 1. 95 gasoline: 95 gasoline is composed of 95% isooctane and 3% n-heptane. High-compression engines should use high-octane gasoline. If low-octane gasoline is used in a high-compression engine, it can cause abnormal combustion, leading to knocking, increased fuel consumption, and reduced driving power. 2. 98 gasoline: 98 gasoline refers to gasoline with an octane rating equivalent to a mixture of 98% isooctane and 2% n-heptane. 98 gasoline offers better anti-knock performance and higher power output, while also containing fewer harmful substances and producing lower exhaust emissions.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.