How to Adjust the Time on Wuling Hongguang?

2 Answers
OViolet
07/25/25 11:15am
The method to adjust the time on Wuling Hongguang is as follows: First, press and hold the 'clock' button until you hear a beep, then release the button. The time display will start flashing. To set the hour, press and hold the 'H' preset button until the hour reading increments to the desired time. To set the minutes, press the 'M' button, following the same principle as setting the hour. Finally, press the 'clock' button again to confirm the set time. The Wuling Hongguang is a model under SAIC-GM-Wuling, with dimensions of 4390mm in length, 1660mm in width, and 1750mm in height, and a wheelbase of 2720mm. In terms of appearance, the Wuling Hongguang features a trendy dual-U front face design and a vertical waterfall-style chrome grille, which not only enhances the dynamic and stylish look of the front but also inherits some characteristics of the GM vehicle series.
Was this review help?
9
3
Share
StJoy
08/11/25 7:58pm
I used to drive a Wuling Hongguang S1, and adjusting the time was quite hassle-free. First, you need to sit in the driver's seat without starting the engine—just turn the key to the ON position. Then locate the small button at the bottom left of the instrument panel labeled 'SET' or with a clock icon. Press and hold it for a few seconds until the hours on the display start blinking. Rotate the adjacent knob to adjust the hour. Briefly press the button once to switch to minutes, then rotate the knob to set them. Finally, press and hold the button to save the settings. The whole process takes about three minutes, but the key is not to do it while driving to avoid distractions and accidents. I’ve also noticed that incorrect time settings can interfere with navigation route planning, especially during long trips, leading to delays—so I check it quarterly. Additionally, the time often resets after a battery disconnect, so mastering this trick saves a trip to the repair shop—just do it yourself. Remember to check the manual or confirm minor model variations, as some older versions use steering wheel controls. Overall, this is a practical routine maintenance task.
Was this review help?
18
1
Share
Expand All
More Forum Discussions

What are the hidden features of the Nissan Sylphy Classic?

Nissan Sylphy Classic hidden features include: One-touch window up/down: When the key is in the on position, during startup or while driving, pull up the left front window switch until the window reaches the top and hold for 5 seconds to activate one-touch window up. For one-touch window down, press and hold the left front window switch until the window reaches the bottom and hold for 5 seconds. Automatic unlock when engine is off: When parking, turning off the engine and removing the key, all four doors will unlock simultaneously. Taking the 2021 manual comfort version Sylphy as an example, its body dimensions are: 4631mm in length, 1760mm in width, 1503mm in height, with a wheelbase of 2700mm, fuel tank capacity of 50 liters, and curb weight of 1188kg.
12
3
Share

What are the conditions for brake fluid replacement?

The conditions for brake fluid replacement are: 1. The brake fluid absorbs moisture or contains impurities; 2. When the vehicle exhibits inconsistent braking performance during normal driving, the brake fluid should be promptly replaced; 3. The wheel cylinder rubber cup expands excessively; 4. The brake fluid should be replaced every two years. The method for replacing brake fluid is: 1. Park the vehicle on level ground, turn off the engine, open the hood, and drain the fluid from the reservoir; 2. Use a funnel to fill the reservoir with new brake fluid; 3. Use a jack to lift the vehicle and start removing the tires from the rear wheels; 4. Remove the rubber dust caps on the brake calipers; 5. Use a wrench to loosen the bleed screws and attach a rubber hose to them, connecting it to a drain bottle; 6. Have someone press the brake pedal inside the vehicle while observing the fluid drainage until the fluid level in the engine compartment reservoir reaches the lower limit.
15
5
Share

What is the first maintenance time for a new car?

New car first maintenance time is 3-5 months, first maintenance mileage is 3000-5000 kilometers. The following introduces the benefits of maintenance: Ensure vehicle safety: A car consists of tens of thousands of components. With use, the performance of functional components (including lubricants) gradually decreases due to wear, aging, corrosion, etc. During normal vehicle operation, this change gradually occurs in many components. Because no two cars are used exactly the same way, it is impossible to predict that every component will wear and age identically. Therefore, periodic inspections allow adjustments and replacements for components expected to change over time or use, ensuring driving safety. Extend vehicle lifespan: Adjusting and replacing components that are expected to change over time or use is called "regular maintenance." Its purpose is to restore the vehicle's performance to optimal condition, prevent small issues from becoming major problems, ensure vehicle safety, and achieve better economy and longer service life. Therefore, car maintenance is essential.
7
0
Share

What is the appropriate tire pressure for a Jetta car?

The optimal tire pressure for a Jetta is between 2.2-2.5 bar. Below is an introduction to tire pressure: 1. Maintaining tire pressure within the standard range during daily driving is a safety awareness that car owners should have. In hot weather, tire pressure should be reduced to prevent blowouts, while in winter, it can be appropriately increased. 2. Increasing tire pressure is suitable for clear winter weather. However, in snowy or icy conditions, higher tire pressure and reduced friction can cause inconvenience and danger. During summer highway driving, the friction between tires and the road generates heat, and on smooth surfaces combined with high ambient temperatures, the original tire pressure can increase significantly. In such cases, it is advisable to reduce the pressure by 0.2 bar to minimize the risk of blowouts. Additionally, avoid speeding in hot weather, as higher speeds increase the likelihood of tire blowouts.
3
2
Share

How to Reset the Maintenance Reminder on Volkswagen Lamando?

To reset the maintenance reminder on the Lamando, follow these methods: Method 1: 1. First, turn off the ignition switch to shut down the vehicle. 2. Then, use your left index finger to press and hold the "0.0" button located below the instrument panel. 3. Next, use your right hand to turn on the ignition switch while keeping the "0.0" button pressed until the maintenance service message appears in English on the instrument panel, then release the button. 4. After releasing, press the "0.0" button below the instrument panel once again within 30 seconds. 5. Once the above steps are completed, the maintenance reminder light will be reset. Method 2: 1. Turn on the ignition switch and press the CAR button located at the bottom left. 2. Tap the settings icon at the bottom right of the screen, then scroll up to find the maintenance option. 3. Click on "Reset Maintenance Information" and confirm to clear the maintenance reminder light.
5
3
Share

What is the battery model for the Touareg car key?

Touareg key battery model is CR2025. CR2032 is a lithium manganese dioxide battery, named according to IEC standards. Among them: C- indicates a chemical battery system with lithium metal as the negative electrode and manganese dioxide as the positive electrode; R- indicates that the battery shape is cylindrical, if it is square, F is used instead; 20 indicates the battery diameter is 20mm; 25 represents the battery height is 2.5mm. The nominal voltage is 3.0V, the endpoint voltage is 2.0V, and the rated capacity varies between 140-170mAh. CR2025 typically has a lifespan of 5 years. If the manufacturer's production level is not high or quality control is poor, its lifespan will be greatly shortened. Domestic first-tier brand batteries can basically guarantee this lifespan. If the usage environment is ideal (sealed, room temperature, no moisture, etc.), its lifespan can be further extended to 8 years or even 10 years. Generally, replacing a car key battery only requires the following 3 steps: Step 1: Remove the mechanical key. Press the lock button on the side of the smart key to remove the mechanical key. Step 2: Open the battery cover. After removing the mechanical key, you can see a deep groove and a shallow groove at the top of the smart key. The deep groove is the keyhole, and the shallow groove is used to open the battery cover. Insert the mechanical key into the shallow groove and pry it outward with force to open the battery cover. After opening, you can see the coin cell battery. Gently pry it out to remove the battery. Step 3: Replace the new battery. Install the new battery, then reattach the battery cover and mechanical key in order, and the key battery replacement is complete.
18
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.