How to Adjust the Time on a Car Dashboard?

1 Answers
AuroraMarie
07/30/25 6:06am
The method to adjust the time on a car dashboard is: 1. Press the left button, and when the time on the trip computer flashes, press the right SET button; 2. Pressing SET adjusts the time once, while holding down the SET button makes the time digits jump quickly. Adjust the time by using both buttons in combination. The car dashboard is a device that reflects the working conditions of various vehicle systems, featuring multiple indicator or warning lights, including: coolant level warning light, fuel level indicator, washer fluid level indicator, charging indicator, high/low beam indicator, transmission gear indicator, anti-lock braking system (ABS) indicator, traction control indicator, and airbag warning light.
Was this review help?
15
0
Share
More Forum Discussions

How to Open the Hood of a Citroen?

Open the driver's side door of the Dongfeng Citroen. Pull up the handbrake to prevent the car from rolling. Pull the hood release lever located on the left side of the driver's leg area. Lift the engine hood upwards. Use the support rod to prop up the hood, ensuring it is securely supported to avoid any hazards.
1
5
Share

How to Open the Trunk of Wuling Hongguang?

Step on the brake pedal of the Wuling Hongguang until it reaches the bottom and cannot be pressed further. Turn the key of the Wuling Hongguang to power on the vehicle. The dashboard lights will illuminate, indicating that the entire electronic system is powered. Press the trunk release button to unlock the trunk. Alternatively, you can manually lift the trunk lid from the outside to open it.
10
0
Share

How to Remove the Door Panel of a 2018 Haval H6?

First, protect the car door. Locate and remove the round cover on the handle, then unscrew the bolt inside. There is also a screw at the power window switch, which can be seen after removing the cover. There is another screw under the handle that is easy to overlook—it also requires removing the cover to access. There is also a screw inside the door pull that needs to be removed.
19
0
Share

How to operate the Citroen Subject 3 lighting simulation?

First, turn on the lights. Start with the high beam. Then switch to the low beam. After that, alternate between high and low beams twice. Next, turn on the hazard lights and fog lights. Finally, turn off all the lights.
7
2
Share

How to Remove a Key Fob?

The first step is to eject the mechanical key. Then use a flat-head screwdriver to pry open the vehicle key. Once the remote key is completely separated, you can see the chip inside the key, the battery, and the key fob part. At this point, you can remove the key fob.
14
4
Share

How to toggle between high and low beams?

Use the lever on the lower left side of the steering wheel, pull it once toward the driver with your thumb and index finger. Then push it in the opposite direction, pulling once toward the front of the vehicle. Toggling back and forth twice will alternate between high and low beams, which should be turned off when meeting another vehicle.
19
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.