How much transmission oil does the Mercedes-Benz C200 need?

1 Answers
ElleFitz
07/29/25 12:21pm
The Mercedes-Benz C200 requires 5 liters of transmission oil. The amount of transmission oil needed for replacement depends on the specific model, as different types of transmissions require different transmission oils. The recommended replacement interval for transmission oil in vehicles is between 60,000 to 80,000 kilometers, but the exact interval should be determined based on the vehicle's usage conditions. The Mercedes-Benz C200 has a body length, width, and height of 4784mm, 1810mm, and 1457mm respectively, with a wheelbase of 2920mm. It is equipped with a 1.5T turbocharged engine paired with a 9-speed automatic transmission. This engine delivers a maximum power of 115kW and a maximum torque of 250Nm.
Was this review help?
10
1
Share
More Forum Discussions

Should the Trunk Drain Plug Be Removed?

It should be removed. Here are the relevant details: 1. Reason: The rubber drain plugs on a car should generally be removed to facilitate water drainage and prolong the vehicle's lifespan. 2. Timely inspection of drain holes: After purchasing a new car, it is essential to promptly check the drain holes on the doors to ensure they are open. If the drain plug is not removed, water can accumulate in the trunk during rain or car washing, leading to rust over time and negatively impacting the car's longevity. Note that there are multiple drain holes on a car, and each typically has a rubber plug.
12
1
Share

What is the condition of engine misfire?

Engine misfire condition includes: 1. Obvious body shaking in idle state; 2. Evident intermittent exhaust gas flow from the vehicle; 3. Insufficient engine power and shortened oil usage cycle; 4. Engine is prone to stalling during operation. Causes of engine misfire: 1. Large wear gap between cylinder liner and piston ring; 2. Poor fuel atomization due to injector wear. An engine is a machine that converts other forms of energy into mechanical energy, including reciprocating piston engines, Stirling engines, steam engines, jet engines, and electric motors. The term engine can refer to both the power generation device and the entire machine including the power unit.
13
5
Share

What Causes the Shuddering During Dual-Clutch Startup?

The reasons for the shuddering during dual-clutch startup: High temperatures inside the clutch cause slight deformation, and replacing the dual-clutch can resolve the issue. If the shuddering is not significant, replacement may not be necessary immediately, and observation is the primary approach. Dual-clutch transmissions differ from conventional automatic transmissions, combining the advantages of manual and automatic transmissions to provide both comfort and power output. While the engine operates at high speeds, gear shifts are typically achieved by gear and clutch actuators, connected to different input shafts. An increasing number of vehicles are adopting dual-clutch transmissions to ensure a better driving experience, enhancing the overall feel of the car's performance.
2
4
Share

Why does the car make a clunking sound when turning?

The reasons for the clunking sound when the car turns are: 1. The sound from the turn signal returning to position. If the turn signal is activated while turning, this sound could be from the return clip of the turn signal's automatic return mechanism; 2. Aging of the steering tie rod ball joint; 3. Steering gear failure. If the abnormal noise is very loud during turning, it might be caused by excessive gear clearance in the steering gear, requiring replacement of the steering gear; 4. Abnormal noise from the stabilizer bar. Loose or damaged stabilizer bar bushings not only produce noise when turning but also when driving on uneven roads. Loose stabilizer bar bushings can be fixed by adding shims.
6
5
Share

Where is the anti-skid switch for the Ford Focus?

The Ford Focus does not have an anti-skid switch. This function is automatically configured within the module and is always enabled by default, with no switch to turn it on or off. The vehicle's anti-skid system operates through the ABS/ASR electronic control unit, which processes signals from the wheel speed sensors to calculate and analyze the wheel slip rate and vehicle speed. Information about the anti-skid system is as follows: 1. The anti-skid system ensures vehicle stability, making it more responsive in situations of oversteer or understeer. 2. In vehicles equipped with an anti-skid system, the system is automatically enabled when the vehicle is powered on. The anti-skid system primarily analyzes data from sensors to maintain optimal dynamic balance during driving.
18
3
Share

Where is the transmission oil filler port for the Trumpchi GS4?

The Trumpchi GS4 does not have a transmission oil filler port. If you need to add transmission oil, you must visit a professional service center where specialized equipment is used for the procedure. The Trumpchi GS4 is a compact SUV under the Trumpchi brand, with body dimensions of 4545mm in length, 1856mm in width, and 1668mm in height, and a wheelbase of 2680mm. In terms of power, the Trumpchi GS4 is equipped with a 1.5-liter four-cylinder turbocharged engine across all models. This engine delivers 169 horsepower and a maximum torque of 265 Nm, which is available from 1700 rpm up to 4000 rpm.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.