···
Log in / Register

How many days does a newly replaced catalytic converter need to run?

1 Answers
Grady
09/01/25 8:44am

The catalytic converter needs to reach a certain temperature before it can function fully and normally. The time required varies depending on the vehicle and external temperature conditions. It could take a few minutes or over ten minutes—there's no standard timeframe. Definition of a catalytic converter: A catalytic converter is the most important external purification device installed in a vehicle's exhaust system. It converts harmful gases such as CO, HC, and NOx emitted from vehicle exhaust into harmless carbon dioxide, water, and nitrogen through oxidation and reduction reactions. Cleaning a catalytic converter: The cleaning method for a catalytic converter involves using an intravenous drip. This method connects a plastic hose to the engine's vacuum solenoid valve and relies on air pressure in the hollow tube to draw cleaning fluid from an infusion bottle into the engine. As the cleaning fluid exits through the exhaust pipe, it cleans the catalytic converter. Lifespan of a catalytic converter: The typical lifespan of a catalytic converter ranges between 80,000 to 100,000 kilometers. The exact lifespan depends on the vehicle's usage conditions, as well as the quality of fuel used and the driving environment.

Was this review help?
1
4
Share
More Forum Discussions

What to Do When Your Car Battery Is Dead?

Check if the battery terminals are loose. Generally, there are clips on the positive and negative terminals of the battery. Inspect whether they are loose or have rust. If there is rust, it is recommended to remove it and then try to start the engine. First, you need to find a rescue vehicle and connect the battery cables of both cars properly. The red cable represents the positive terminal, and the black cable represents the negative terminal. Then, directly connect the two cars to the corresponding positive and negative terminals. After connecting, the rescue vehicle should start first, then power the rescued vehicle to attempt ignition.
16
3
Share

How to Remove the Gear Knob of Baojun 630?

First, inspect the gear knob of the SAIC-GM-Wuling Baojun 630 Start by prying off the plastic cover on the gear knob of the SAIC-GM-Wuling Baojun 630 Next, remove the clip under the dust cover of the SAIC-GM-Wuling Baojun 630 gear knob Finally, pull it hard to remove the gear knob of the SAIC-GM-Wuling Baojun 630
7
3
Share

How to Repair Scratches on Aluminum Alloy Wheels?

If the scratch has not reached the inner side of the wheel, it can be easily repaired. Use paint thinner to wipe around the scratch to remove dirt; For the deepest part of the scratch, dirt may be difficult to remove. In this case, use a toothpick to clean it thoroughly; Prepare the tip of a brush, apply touch-up paint, and let it dry, during which it will slightly shrink. After drying, use waterproof paper dipped in soapy water to smooth the surface. Once wiped with waterproof paper, use a polishing compound to restore shine, and then apply wax.
1
2
Share

How to release the P gear on Audi A6?

First, open the ashtray cover plate at the front of the gear lever and remove the ashtray box Use a key or screwdriver to pry out the black plastic piece at the bottom of the ashtray Insert the onboard screwdriver, ballpoint pen, or small wooden stick into the small hole on the left side, and press down vertically on the unlocking mechanism below the small hole While pressing down the unlocking mechanism, pinch the unlock button on the gear lever, and the gear can be smoothly released
19
5
Share

How to Report a Car Insurance Claim?

In the event of an accident, report the claim to the insurance company within 48 hours. After reporting, the insurance company will assign a specialist to investigate and assess the vehicle damage. For minor single-vehicle accidents, on-site damage assessment is conducted; for multi-vehicle or severe damage accidents, assessment is done at a designated damage assessment center. Handle the car insurance claim and submit the necessary documents. Submit all required documents to complete the car insurance claim process and receive the claim payment.
3
1
Share

How Does a 4S Shop Compensate for Oil Seal Leakage in a New Car?

If oil leakage occurs in a new car, you can drive the car to the 4S shop for inspection. If it's a minor issue, the 4S shop can replace the parts for free. If it's a more serious quality problem that causes the oil leakage, you can directly request the 4S shop to refund the car. If the 4S shop refuses to refund the car, you can file a lawsuit directly, in which case the 4S shop may have to refund the car and compensate three times the amount.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.