Does a New Car Come with Engine Oil and Coolant?

2 Answers
McGabriel
07/29/25 7:35am
New cars do come with engine oil and coolant, and they are filled to the standard level with sufficient quantities. This is because the vehicle needs to undergo a series of subsequent tests, and without these fluids properly added, the follow-up processes cannot proceed. The method for replacing coolant is as follows: Before completely replacing the coolant, conduct a thorough inspection to check for any signs of leakage or cracks in the pipes, with special attention to the five-way water pipe. The coolant flows through this pipe and is then distributed to different parts of the car to perform its functions. If there is any coolant leakage in this section, replace the water pipe or resecure the connection as needed. Drain the old coolant, then flush the fluid channels with clean water. Add clean water to the coolant reservoir, then continuously inject water into the reservoir so it circulates through the engine cooling system. Let the engine idle for 3 to 5 minutes to allow the water to circulate. Initially, the water flowing out of the reservoir may have a faint pink tint. Continue adding clean water until the outflowing water runs clear. Note: Remember to remove the heater hose and drain the water from the heater core. After draining for about an hour, add the new coolant through the radiator hose. Then, pour another container of coolant into the coolant reservoir until it is nearly full. Start the engine and let it run for about 10 minutes. During this time, the coolant level will drop slightly as air is purged from the cooling system. Top up the coolant again until it reaches the "MAXT" mark on the reservoir.
Was this review help?
20
4
Share
GarrettFitz
08/13/25 1:27am
I just bought a new car and was excited to check under the hood during pickup. Of course, a new car comes with engine oil and coolant pre-filled at the factory before delivery! Engine oil is used to lubricate internal engine components, reducing friction and wear; coolant circulates in the cooling system to prevent engine overheating or freezing in winter. As a car owner, I pay special attention to these fluid levels during the break-in period—for example, checking the dipstick and coolant reservoir monthly. During the first maintenance service for a new car, a comprehensive fluid inspection is recommended to ensure freshness. Neglecting this could lead to engine damage, so I strictly follow scheduled replacements, usually once a year or as per the manual’s reminders. Regular maintenance keeps a new car running longer and safer.
Was this review help?
12
4
Share
Expand All
More Forum Discussions

What Causes a Scooter to Fail to Start in Winter?

The reasons why a scooter fails to start in winter include fuel system failure, electrical circuit failure, etc. Specific explanations are as follows: Fuel System Failure: Mainly caused by issues such as the fuel switch (not delivering fuel), fuel filter (blockage), carburetor (not supplying fuel or having an overly rich mixture), or bent fuel lines. Electrical Circuit Failure: Short circuits in the vehicle's electrical components (e.g., ignition switch, ignition coil, ignition module, and magneto failure) or open circuits caused by loose wiring harness connectors. Air Pressure Failure: Insufficient cylinder compression, improper air intake resistance of the air filter element, or engine intake and exhaust faults, etc. No Fuel in the Scooter: Before starting, check whether the motorcycle's fuel switch is open and whether there is gasoline in the fuel tank.
2
5
Share

What Causes a Weak Starter?

The reasons for a weak starter include system malfunctions and poor ignition system performance. The specific details are as follows: System Malfunctions: Air leaks in the intake system; low fuel pressure; clogged air filter; faulty coolant temperature sensor; malfunctioning mass airflow sensor; issues with the idle control valve or auxiliary air valve; non-functioning cold start injector; leaking fuel injector; incorrect ignition timing; broken wiring from the starter switch to the ECU; low cylinder compression pressure. Poor Ignition System Performance: For example, aging ignition coils or spark plugs that haven't been replaced for a long time can lead to insufficient ignition energy, poor combustion, weak engine acceleration, and the engine warning light turning on. Replacing the ignition system components can resolve this issue. Fuel System Malfunctions: Fuel system issues causing low pressure and insufficient fuel injection can result in weak engine acceleration. It is necessary to inspect and replace the fuel filter and fuel pump.
1
4
Share

Can You Continue Driving with Overinflated Tires?

You should not continue driving with overinflated tires. When tire pressure is too high, although rolling resistance is significantly reduced and vehicle fuel consumption noticeably decreases, the contact area between the tire and the ground diminishes, resulting in poorer tire grip. Hazards of overinflated tires: Reduced friction and adhesion of the tires, affecting braking performance; Causes steering wheel vibration and deviation, reducing driving comfort; Accelerates localized wear of the tread pattern in the center of the tire, shortening tire lifespan; Increases vehicle body vibration, indirectly affecting the lifespan of other components; Excessive stretching deformation of tire cords, reducing tire elasticity and increasing the load on the vehicle during driving; Decreases puncture resistance. When encountering sharp objects like nails or glass on the road, they can easily penetrate the tire, causing internal cracks and blowouts due to impact, leading to tire bursts.
12
0
Share

What Causes the Starter Not to Turn When the Engine is Hot?

When the starter does not turn while the engine is hot, the reasons may include battery issues, electromagnetic switch problems, and more. Specific explanations are as follows: Battery Issues: Insufficient battery charge, loose cable connections, or dirty terminals causing poor contact. Electromagnetic Switch Problems: Short circuit in the starter electromagnetic switch coil or poor contact of the contact disc. Relay Problems: Burnt relay contacts, open circuit or burnout of the relay magnetic coil. Internal Armature Shaft Issues: Bent armature shaft inside the starter, overly tight bearings, dirty or burnt commutator, excessively worn brushes, weak springs preventing contact, short circuit, open circuit, or grounding in the armature or field coils. Anti-Theft System Problems: Fault in the starter anti-theft system.
17
5
Share

How to Set the Time on a 2008 Corolla?

To set the time on a 2008 Corolla using the multi-function steering wheel: 1. Start the vehicle with the car key; otherwise, the time cannot be adjusted. 2. Press the DISP button to activate the LCD screen's time display. 3. The LCD screen will show the time setting. 4. Press the H key on the time display screen to start adjusting the hour. 5. Use the volume increase and decrease buttons on the steering wheel to adjust the time. 6. Press the M key on the time display screen to start adjusting the minutes. The dimensions of the 2008 Corolla are 4630mm in length, 1775mm in width, and 1480mm in height, with a wheelbase of 2700mm.
16
4
Share

What are the main causes of damage to a car's chassis?

Car chassis damage is caused by external corrosion and scratches from foreign objects or hard materials. The specific details are as follows: External corrosion: Due to improper driving by the owner, such as driving into muddy puddles on rainy days without promptly cleaning the chassis. Failing to wash the car promptly after rain can also lead to gradual corrosion of the chassis by weakly acidic rainwater, especially in areas with severe urban pollution. Scratches from foreign objects or hard materials: When driving on uneven suburban roads, the car may bottom out, allowing foreign objects to scratch the chassis. Some cars naturally have low ground clearance, making them highly susceptible to chassis scratches when frequently driven on rural or suburban roads.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.