Do I Need to Replace Two Tires?

1 Answers
ZoeyRose
07/29/25 7:41pm
Tires do not necessarily need to be replaced in pairs. If a tire has a bulge due to impact, severe sidewall damage, has been punctured more than four times, or has a puncture hole larger than 6mm, you may choose to replace either one tire or a pair, depending on the situation. For a new car with relatively low mileage, you only need to replace the problematic tire, as the wear on tires on the same axle is usually similar. However, if the tires have already been driven tens of thousands of kilometers but do not yet require replacement, and only one tire has an issue, replacing just one tire may cause uneven height, leading to bumpiness or steering pull at higher speeds. In such cases, it is recommended to replace a pair of tires.
Was this review help?
11
2
Share
More Forum Discussions

How to Remove the Radio in a Chevrolet Sail?

To remove the radio in a Chevrolet Sail, follow these steps: 1. Pull the panel below the air conditioning buttons by hand, then pull the panel below the radio. Use a screwdriver to remove the four screws securing the radio. 2. Pull out the radio, disconnect the rear wiring harness, and remove the radio antenna. Then install the DVD player, connect the rear wiring harness to the DVD player, and attach the DVD player's GPS antenna to the metal pipe under the dashboard. 3. Reconnect the original radio antenna, tighten the four screws, and firmly press the panel back into place. 4. When parked, it's best not to listen to the radio for more than half an hour to avoid draining the battery. Since the battery is charged by the engine and cannot charge while the vehicle is parked, prolonged radio use can quickly deplete the battery, causing significant damage.
19
1
Share

What kind of engine oil is generally used for small cars?

Small cars generally use fully synthetic engine oil. Main characteristics of engine oil: Engine oils on the market can be simply divided into two types based on their base oil: mineral oil and synthetic oil (vegetable oil is not considered due to its scarce production). Synthetic oils are further divided into: fully synthetic and semi-synthetic. Lubricant base oils are mainly categorized into mineral base oils and synthetic base oils. Mineral base oils are widely used and consumed in large quantities, but some applications require products blended with synthetic base oils. Engine oil classification standards: 10W-40 is its SAE standard viscosity value. This viscosity value first indicates that the oil is a multi-grade oil. W stands for WINTER, and the number before W represents the oil's flow performance at low temperatures; the smaller the number, the better the starting performance at low temperatures. The number after W represents the oil's stability at high temperatures (i.e., the likelihood of thinning); the larger the number, the better the oil's stability at high temperatures.
20
2
Share

Is Engine Crankshaft Oil Seal Leakage a Major Issue?

Not a major issue, but it does have some impact. Valve oil seal leakage can accelerate oil consumption and cause blue smoke from the exhaust pipe, but it has little effect on engine power. The valve oil seal prevents oil from entering the intake and exhaust pipes, thereby avoiding oil loss. It also prevents the leakage of the air-fuel mixture and exhaust gases, and stops engine oil from entering the combustion chamber. Below is extended information about oil seals: Function: An oil seal is a mechanical component used to contain lubricants, commonly found in the bearing areas of various machinery. Its primary function is to isolate lubricated parts from the external environment, preventing lubricant leakage. It serves the dual purpose of sealing oil internally and keeping out dust externally. Materials: Modern oil seals are primarily made from various types of rubber, such as nitrile rubber, acrylic rubber, polyurethane rubber, silicone rubber, fluororubber, and polytetrafluoroethylene rubber. The typical structure of an oil seal is as shown in the figure below, offering advantages like simple design, lightweight, compact installation space, and ease of manufacturing.
5
4
Share

What is the charging power of a charging pile?

The charging power varies for different vehicle models. It is generally 160 or 240. Below is some information about the radiation from charging piles: Safety: The electromagnetic radiation generated by electrical appliances has no significant impact on the human body (the sunlight we see every day is a form of electromagnetic radiation), as the intensity of electromagnetic radiation is limited by safety standards. Ionizing radiation has a greater impact on humans (such as what is commonly referred to as nuclear radiation), but it also naturally exists at a certain intensity, and there is no need to worry about it in normal life. Radiation intensity: First, let's look at the national standard regulations. For low frequencies between 1-8 Hz, the permitted public exposure values are: electric field strength of 8000V/m and magnetic field strength of 500A/m, meaning that any intensity below these values is considered acceptable. Taking the commonly used Guoxuan lithium-powered buses and BYD K-series electric buses as examples, the measured electric field strength is 1-2V/m, and the magnetic field strength is 2-4A/m. When the vehicle speed exceeds 40km/h, the electric field strength inside the cabin is below 1A/m, and the magnetic field strength is below 0.05A/m. These values are so small that they can be considered negligible, far lower than those of a typical smartphone.
10
0
Share

Is There Warranty for Brake Discs at 4S Stores?

Brake discs are covered by warranty, typically for 12 months or 60,000 kilometers. Of course, the warranty period varies for different car brands. More details are as follows: Importance of Brake Discs: Good brake discs provide stable braking, no noise, and no vibration. The material of the brake discs conforms to China's gray cast iron 250 standard, abbreviated as HT250, which is equivalent to the American G3000 standard. Factors Affecting Brake Discs: Brake discs are cast products. Due to climatic factors—extreme cold in the north and extreme heat in the south—most brake disc production bases are located in the latitude regions of Shandong, Hebei, and Shanxi in China. Currently, there are disc brakes and drum brakes. Older vehicles often have disc brakes in the front and drum brakes in the rear. Many vehicles now have disc brakes on both front and rear wheels. Because disc brakes dissipate heat better than drum brakes, they are less prone to thermal fade during high-speed braking, resulting in better high-speed braking performance.
12
5
Share

Do I need to go in person for the license plate registration?

New car license plate registration can be handled by someone else, as long as the ID card provided by the owner matches the name and ID on the invoice of the car purchaser. Notes for new car license plate registration: Exempted vehicle models: Although imported motor vehicles and some domestic cars, small and mini passenger vehicles have been included in the exemption scope, the number of exempted domestic car models is relatively small. After the implementation of the new policy, all domestic cars can be exempted. The exemption scope for new cars includes sedans and small, mini passenger vehicles and two-wheeled motorcycles marked with "new car exempted." Exempted vehicle models do not include: Exempted vehicle models do not include off-road vehicles, small and mini ordinary passenger vehicles, and medium and heavy-duty trucks. Exemption does not mean direct license plate registration: Exemption for new cars does not mean you can directly go for license plate registration. Currently, it only exempts some items from the on-site inspection. New cars still need to undergo appearance inspection, photo-taking, and number stamping at the inspection site before license plate registration. Additionally, the exhaust emission test required for environmental protection purposes must still be conducted.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.