···
Log in / Register

Can Subject 1 and Subject 2 be taken at the same time?

4 Answers
DiAaron
08/26/25 3:22am

Subject 1 and Subject 2 cannot be taken simultaneously. You can schedule the Subject 2 test online 10 days after passing Subject 1. According to the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses," the registration requirement for Subject 2 is completing 26 training hours, including 2 hours of theoretical knowledge, 3 hours of simulated driving, and 21 hours of practical driving. For a C1 driver's license, you can schedule the Subject 2 test online 10 days after passing Subject 1. Each Subject 2 test appointment includes two attempts. If you fail the first test, you can take a free retest. If you skip the retest or fail it again, the test session ends, and you can reschedule the Subject 2 test after 10 days. Within the validity period of the driver's license learning process, you can schedule the Subject 2 test up to 5 times. If you fail the fifth attempt, all previously passed subjects will be invalidated. To continue the driver's license learning process, you must restart from Subject 1. Subject 2 test content: Driving a motor vehicle to complete test items within a designated area; mastery of motor vehicle driving skills; ability to judge the spatial position of the vehicle. Subject 2 is also known as the "small road test" and includes five required items: reversing into a parking space, parallel parking, stopping and starting on a slope, turning at a right angle, and driving through curves. Subject 2 test precautions: After getting in the car, adjust the seat and mirrors to the proper position and state, and always fasten your seatbelt. For parallel parking, find the correct angle quickly, turn the steering wheel rapidly, and coordinate with the vehicle's speed. For stopping on a slope, remember to pull the handbrake, turn on the left turn signal when starting, and release the handbrake. Control the clutch steadily while pressing the accelerator to avoid stalling or rolling back. For turning at a right angle, react quickly after identifying the correct point and coordinate with the vehicle's speed to avoid deviation. For driving through curves (S-curve), slow down. Those with good driving sense can pass through smoothly in one go. For reversing into a parking space, control the speed, identify reference points, and make minor adjustments if the rearview mirror shows any deviation. The driver's license test consists of three subjects: Subject 1, Subject 2, and Subject 3. Subject 1 refers to the test on road traffic safety laws, regulations, and related knowledge. Subject 2 refers to the field driving skills test. Subject 3 is divided into two parts: road driving skills and safe and civilized driving knowledge. The safe and civilized driving knowledge test is conducted after Subject 3, so it is commonly referred to as Subject 4. However, the official term (as per the Ministry of Public Security's Order No. 123) does not include "Subject 4."

Was this review help?
1
3
Share
EmeryLynn
09/08/25 3:52am

I just got my driver's license last month and specifically asked my instructor about this. The driving test must be taken in order—if you don't pass the written test (Subject 1), you can't even sign up for the practical skills test (Subject 2). Subject 1 covers all the traffic laws and driving theory; only after passing the written test can you start handling the car. Subject 2 involves practicing technical skills like parallel parking—you need to fully grasp the theory before getting behind the wheel. I once saw a student who failed Subject 1 sneak off to the training lot, but he couldn't understand anything, wasted his time, and nearly crashed into other cars. So don't even think about doing both at once—focus first on passing Subject 1, and getting your license will come quickly. The whole process is designed for safety: solid theoretical knowledge ensures you won't panic when handling the actual car.

Was this review help?
14
3
Share
Expand All
SanMaya
10/22/25 3:56am

As a driving school staff member, I'm very familiar with the daily process of handling student exam registrations. The system is set up so that passing Subject 1 unlocks the booking permission for Subject 2 - simultaneous testing isn't possible. Some students often ask if they can start practicing early, but we strictly follow regulations: they must present their Subject 1 passing record before we can assign instructors and arrange training grounds. After all, it's too dangerous to get behind the wheel without basic traffic rule knowledge. Just last week, a student who hadn't passed Subject 1 wanted to practice hill starts, but didn't even know the turn signal rules. It's much safer to follow the exam sequence properly - Subjects 2 and 3 can be completed in three weeks anyway, there's no need to rush.

Was this review help?
16
0
Share
Expand All
LeAllie
12/05/25 4:18am

The design of the driver's license test is actually very scientific. The theoretical knowledge in Subject 1 lays the foundation, while the practical skills in Subject 2 build the house. How can you build without a solid foundation? When I was learning to drive, my instructor said that if you don't master the signs, markings, and rules in Subject 1, you won't even know what you did wrong when you hit the line during the right-angle turn in Subject 2. Nowadays, the driving test systems across different regions are all interconnected. If you don't pass Subject 1, your file won't even be activated, let alone enter the Subject 2 test site. I remember a friend who tried to find a loophole but was directly blocked by the system outside the Subject 2 test site. Just honestly go through the Subject 1 question bank. Spend half an hour every day on a mobile app, and you'll surely pass in two weeks.

Was this review help?
19
2
Share
Expand All
More Forum Discussions

What is the symbol for engine overheating?

The symbol for engine overheating is a thermometer with two wavy lines beneath it. Below is relevant information about engine overheating: 1. Causes of engine overheating include: leakage or insufficient coolant in the cooling system; inaccurate or malfunctioning temperature gauge; excessive scale buildup in the cooling system, reducing heat dissipation efficiency; blockage of the radiator grille or core ventilation passages by debris, leading to poor heat dissipation; loose or broken water pump or fan belt, etc. 2. Methods to prevent engine overheating: ensure adequate coolant levels; check if the thermostat is functioning properly; park in shaded areas; monitor the temperature gauge while driving to ensure it does not exceed 95°C; in special circumstances, to enhance cooling air convection, the engine hood can be opened to facilitate ventilation and heat dissipation.
11
0
Share

How Many Liters of Engine Oil Does a Highlander V6 Require?

Toyota Highlander typically requires approximately 4.5L of engine oil, with the exact amount determined by the oil dipstick's scale marks. Below are precautions for adding engine oil to a Highlander: 1. Add the Appropriate Amount: If too much engine oil is added to the Toyota Highlander, it increases the amount of oil splashed onto the cylinder walls by the rotating crankshaft and connecting rods. This results in significantly more oil entering the combustion chamber, leading to increased carbon deposits in the chamber. These deposits raise piston movement resistance, reducing engine power. Additionally, excessive oil entering the combustion chamber worsens exhaust emissions, negatively impacting the lifespan of the three-way catalytic converter. In severe cases, it may even damage the converter. 2. Use Consistent Engine Oil: When topping up the Highlander's engine oil, it's advisable to use the same type of oil already in the engine. Avoid mixing different brands or varieties of engine oil to prevent potential reactions between the different additives in the oils.
8
4
Share

Do You Need to Press the Clutch When Making a U-Turn in Second Gear?

You do not need to press the clutch when making a U-turn in second gear. Here are the relevant details: 1. When turning: When encountering a turn, slow down and turn while in gear. If the speed is too fast and you press the clutch, the car may accelerate, leading to a skid. 2. In heavy traffic: If making a turn at a congested intersection, you can use first or second gear, press the clutch, and rely on the car's idle speed to turn. Keep your foot on the brake to prepare for any sudden situations. 3. Real-world scenarios: In actual situations, the conditions may be more complex. You should also consider the size of the curve and road conditions. However, always remember to control your speed before turning—brake to reduce speed, decelerate less for wide turns and more for sharp turns.
15
2
Share

Can Windshield Washer Fluid Be Mixed with Tap Water?

Automotive windshield washer fluid should not be mixed with tap water. Here is the relevant information: 1. Windshield washer fluid: It is mainly composed of water, alcohol, ethylene glycol, corrosion inhibitors, and various surfactants. The water here refers to purified water. 2. Reason: Ordinary tap water is not recommended for use as it contains many impurities. Over time, these impurities can adhere to the rubber pipes, affecting normal spraying. Long-term use may increase friction between the glass surface and the wiper blades, causing scratches on the glass. In fact, plain water can only clean dust simply and does not have the ability to thoroughly clean dirt or insect residues on the windshield.
6
4
Share

Does driving an electric vehicle through deep water have any impact?

Electric vehicles can be affected when driving through deep water; it's advisable to avoid water whenever possible. When encountering standing water on the road: Ensure the road conditions are good, and if the water does not exceed half the height of the tires, slow down, observe the situation of the vehicle ahead, and proceed in order. When encountering flooded sections: Regardless of the water depth, do not attempt to pass. The vehicle can easily be pushed off the road and swept away by strong currents, and the road surface underwater may already be completely damaged by the water flow. If you accidentally drive into deep water: If the vehicle begins to float, immediately open the doors to allow water to enter the cabin, which can reduce buoyancy and help the wheels regain traction. If you are certain the water ahead is not too deep and the vehicle has not 'stalled,' continue moving forward to a safe area. If the vehicle has stalled, this can also prevent the doors from being unable to open, avoiding a situation where escape is impossible. After driving through water: Contact after-sales service and insurance immediately. Vehicles that have been through water may have many hidden hazards and should be thoroughly inspected before being driven again.
16
3
Share

What is the reason why the in-car QQ Music in Haval H6 cannot be played?

Haval H6's in-car QQ Music cannot be played mostly due to Bluetooth connection issues or the playback source not being switched to Bluetooth mode. Details are as follows: Playback source not switched to Bluetooth mode: The vehicle Bluetooth has been successfully connected, but only the phone function is available, and music cannot be played. The most common issue is that the vehicle has not switched the playback source to Bluetooth mode, with the vehicle system defaulting to normal playback mode. After switching, the issue can be resolved. Bluetooth connection unsuccessful: When the device malfunctions, it may cause the Bluetooth to fail to connect. If the vehicle Bluetooth cannot connect, try deleting the matched devices from both the vehicle host and the phone, then reconnect. If it still cannot connect, try using another phone or Bluetooth device for connection. If it connects successfully, the issue lies with the phone or other Bluetooth device, and it is recommended to replace or upgrade the device. If it still cannot connect, try restarting the entertainment system host or disconnecting the vehicle's power supply before attempting again. If the issue persists, it is necessary to visit a repair facility to check the status of the entertainment system host's Bluetooth module and perform maintenance or software upgrades.
8
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.