Are there any restrictions for Beijing-licensed vehicles leaving Beijing?

1 Answers
JoyMarie
07/30/25 5:13am
Beijing-licensed vehicles should not leave Beijing on restricted days. The following is an introduction to Beijing-licensed vehicles: 1. For vehicles that genuinely forget the restricted day and unintentionally drive out, Beijing-licensed vehicles will only be fined without penalty points; non-Beijing-licensed vehicles will not only be fined but also receive 3 penalty points. After receiving one penalty, the driver has 3 hours to drive the vehicle out of the restricted area, to the nearest parking lot, or back to the starting point without worrying about further penalties. However, if the vehicle continues to drive out within the same day, it will be penalized repeatedly. 2. For vehicles holding an entry permit for Beijing: On weekdays (Monday to Friday), from 7:00 to 9:00 and 17:00 to 20:00, driving is prohibited within the Fifth Ring Road. In addition to the above regulations, non-local vehicles must also comply with Beijing's peak-hour restrictions and odd-even license plate rules from 9:00 to 17:00 on weekdays, with the restricted area being within the Fifth Ring Road (inclusive). The license plate tail number rotation follows Beijing's motor vehicle license plate tail number rotation method.
Was this review help?
3
3
Share
More Forum Discussions

Which brand of engine oil is suitable for the Sylphy?

Original equipment manufacturer (OEM) engine oil is the most suitable for the Sylphy. For the selection of engine oil brands, if you require long-lasting performance, you can choose Mobil lubricants; if you prioritize the cleaning ability of the oil for the engine, Shell engine oil is recommended; for strong oil film toughness, Castrol is suggested. Below is an introduction to winter engine oil: Winter oil grades are 0W, 5W, 10W, 15W, 20W, and 25W. The symbol W stands for Winter, and the smaller the number before W, the lower the low-temperature viscosity, the better the low-temperature fluidity, and the lower the applicable minimum temperature.
18
5
Share

What are the shifting-up techniques for a 4AT transmission?

Here are the shifting-up techniques for a 4AT transmission: 1. P (Park) gear: This is the parking and starting gear. When parking and turning off the engine, the vehicle should be shifted into this gear, which locks the transmission to prevent rolling and potential damage. Additionally, the engine can only be started when the gear is in P or N. 2. N (Neutral) gear: This means no gear is engaged. When in this gear, special attention should be paid if the vehicle is on a slope, and the brake should be used skillfully to prevent the vehicle from rolling. 3. D (Drive) gear: This is the forward driving gear. In D gear, the vehicle can automatically control and shift between gears 1 to 4 based on the driving speed and road conditions to achieve smooth driving.
2
1
Share

What Volvo Technologies Are Used in Lynk & Co Cars?

Lynk & Co cars utilize Volvo technologies for their chassis and engines, but not for the transmission. Below is an introduction to the Lynk & Co 02: 1. Body dimensions: The length, width, and height are 4448/1890/1528mm respectively, with a wheelbase of 2702mm. 2. Features: It comes with a spoiler, front and rear radars, rear camera, wheel rim styles, front and rear bumper designs, and lower side trim panels. The Lynk & Co 02 is equipped with tires sized 215/60R17. 3. Exterior design: The split-type headlights, polygonal front contour lines, and horizontal grille give the vehicle a highly distinctive appearance.
15
2
Share

Has the Volkswagen Lavida met China VI emission standards?

Volkswagen Lavida has a China VI version. Here is more information about the Volkswagen Lavida: 1. Dimensions: The 2021 Lavida has a body length of 4670mm, width of 1806mm, and height of 1474mm, with a wheelbase of 2688mm. 2. Powertrain: The new Lavida is equipped with a 1.5L naturally aspirated engine and a 1.4T turbocharged engine. The 1.5L engine delivers a maximum power of 113 hp (112 hp for some versions) and a peak torque of 145N·m, while the 1.4T engine produces a maximum power of 150 hp and a peak torque of 250N·m.
16
2
Share

How to Adjust Vehicle Rearview Mirrors Properly?

Adjusting car rearview mirrors involves the following steps: 1. For the center rearview mirror, adjust the horizon line reflection to the center of the mirror, and position the reflection of your right ear to the left edge of the mirror. 2. For the left side mirror, adjust the horizon line reflection to the center of the mirror, and position the reflection of your car's left side to occupy one-fourth of the mirror's right side. 3. For the right side mirror, adjust the horizon line reflection to two-thirds of the mirror's height, and position the reflection of your car's right side to occupy one-fourth of the mirror's left side. The function of car rearview mirrors is to reflect conditions behind, beside, and below the vehicle, thereby expanding the driver's field of vision.
10
4
Share

What is the equivalent speed of 25km/h?

25km/h is equivalent to 25 mph, while in foreign countries it is 40 mph. Below is relevant information about 25km/h: 1. Conversion: Originating from the speed unit "mile." One mile per hour is approximately equal to 1.6 kilometers per hour. Later, the metric system became internationally standardized. The commonly referred speed of 100 mph equals 100 kilometers per hour, while the British term 100 mph equals 160 kilometers per hour. 2. Speed: Speed is a form of expression indicating the total distance an object travels in one hour. The unit of speed is kilometers per hour. Speed is commonly used in the field of transportation but is not the standard speed unit in the International System of Units.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.