To ensure a strong and lasting bond when mounting your Q-TRAN LALO Linear Fixture with VHB adhesive, proper surface preparation is key. Here’s a detailed guide:
-
Ideal Application Conditions: Aim for an environment between 70-100°F with humidity at or below 50%. The minimum application temperature should be 50°F. Maintain these conditions for 72 hours after installation to maximize adhesive strength.
-
Cleaning the Surfaces:
- Thoroughly clean both the back of the Q-TRAN LALO Linear Fixture and the surface where it will be installed using a 50/50 alcohol mixture.
- Allow the surfaces to dry completely for approximately 5 minutes before proceeding.
-
VHB Adhesive Application:
- Peel back about 0.5 inches of the protective film from one end of the VHB tape.
- Carefully apply the adhesive to the surface, using firm pressure to avoid air bubbles.
- Continue peeling and applying in small sections until the entire fixture is securely adhered.
-
For Porous Materials:
- If mounting on porous materials like wood, brick, or concrete, apply two coats of paint or primer to create a smoother, more adhesive-friendly surface.
-
Recommended Epoxies for Specific Materials: Consider using the following epoxies based on your mounting surface:
- Concrete, Stone, Cinderblock, Metal, and Brick: Loctite Metal and Concrete Two-Part Epoxy
- ABS, Fiberglass, Plastic, and PVC: Loctite Plastic Two-Part Epoxy
- Tile, Wood, Ceramic, Glass, or Metal: Loctite Clear Two-Part Epoxy
- All-Purpose: Strong Stik
Following these steps and using the recommended materials will help you achieve a successful and durable installation of your Q-TRAN LALO Linear Fixture using the VHB adhesive method.
