What are the correct wiring steps for the NOTIFIER B710LP Plug In Detector Base?

[VonOlive]

To ensure correct installation of your NOTIFIER B710LP Plug In Detector Base, adhere to these wiring guidelines: First, utilize color-coded conductors to minimize wiring errors between smoke detectors, control panels, and accessory devices. Second, for signal wiring, use a wire no smaller than AWG 18, although the base accommodates up to AWG 12. Third, it is recommended to use twisted pair wiring or a shielded cable for the power loop to reduce electrical interference. Ensure the shield connection is continuous. Fourth, strip approximately 3/8” of insulation from the wire, insert the bare end under the clamping plate, and tighten it securely. Do not loop the wire. Fifth, before installing detector heads, check the zone wiring for continuity, polarity, and perform dielectric tests. Finally, use the label on the base to record the zone, address, and detector type; this is crucial for setting the detector head's address. Following these steps ensures your NOTIFIER B710LP Plug In Detector Base functions correctly in your 2-wire intelligent system.