
Certainly! Here's a straightforward guide to installing the Spex Stylo Heavy-Duty Compatibility Kit:
Begin by securing the Mounting Block to the Stylo HDCK Plate. Use the M6 x 25mm screws and washers that came with the Mounting Block. A 4mm hex key is needed to tighten these screws.
Next, connect the Stylo HDCK Plate to the Back Support. Use the M6 x 25mm bolts and washers from the fastener kit. Again, a 4mm hex key will be required to tighten the bolts.
With the ball firmly clamped in the Stylo 160 or Stylo 260 mechanism, insert the M4 x 10mm grub screws into the threaded hole found on the opposite side of the clamp. Tighten these screws against the ball to lock it further in place. Use a 2mm hex key for this step.
Please remember that this is a supplemental installation guide. For comprehensive details and important safety information, always consult the Head Support User Manual included with your Head Support. For further assistance or inquiries, please contact Spex Ltd at fasterresults@spexseating.com, call +643 307 9790, or visit their website at www.spexseating.com.


