Need help installing Select Blinds Designer Double Cell Blackout Honeycomb Shades?

[VonHarrison]

Absolutely! Here's how to install your Select Blinds Designer Double Cell Blackout Honeycomb Shades:

Inside/Ceiling Mount:

1. Position the shade and mark the front edge.
2. Measure 3" in from each end and mark.
3. Mark bracket locations and center additional brackets if necessary.
4. Position brackets 5⁄16" from the window casing for a flush mount.
5. Drill holes at the marked spots.
6. Secure the brackets.
7. Mount the shade into the brackets.
8. Attach cordless lift handles. For shades up to 24" wide, center one on the bottom rail. For larger shades, attach two evenly spaced. To lower, pull down; to raise, lift up.

Outside Mount:

1. Place the shade and mark the corners.
2. Measure 3" in from each end and mark.
3. Mark bracket locations and center additional brackets if needed.
4. Drill holes.
5. Secure the brackets.
6. Mount the shade into the brackets.
7. Attach cordless lift handles.

Optional: Extension Brackets: Use extension brackets for added projection; follow the outside mount steps, using the extension brackets.

Optional: Hold-Down Brackets: Install these to secure the shade's bottom, according to the manual.

Optional: Side Mount (for shades 60" or less in width): Assemble brackets and measure from the window casing to the front of the bracket based on your shade type (3⁄8" Single Cell: 13⁄8", 1" Pleated Shades: 15⁄8", 3⁄4" Single Cell/1⁄2" Double Cell/2" Pleated Shades: 15⁄8", 11⁄4" Single Cell Shade: 23⁄8"). Install side mounts accordingly.

Refer to the diagram and manual for visual guidance.