Installing an EMTEK Single Cylinder Deadbolt Lock on a regular door involves a few key steps. Here's a breakdown to guide you:
-
Door Preparation:
- Start by measuring and marking the height where you want to place the deadbolt on the edge of your door.
- Using a hole saw, drill a 2-1/8" diameter hole through the door at your marked height.
- Next, drill a 1" diameter hole from the door's edge to meet the 2-1/8" hole. This creates space for the latch.
-
Door Jamb Preparation:
- Measure and mark the matching height on the door jamb for the strike plate.
- Use a chisel to create a mortise, recessing the strike plate into the door jamb at the marked height.
-
Latch Installation:
- Insert the latch into the 2-1/8" hole on the door edge. Make sure the beveled side of the latch faces the direction your door closes.
- Secure the latch to the door with the screws provided.
-
Exterior Assembly Installation:
- From the outside of the door, insert the exterior assembly into the latch.
- Align the appropriate holes on the exterior assembly with the holes in the latch mechanism.
- Attach the exterior assembly by tightening the provided screws.
-
Interior Assembly Installation:
- Now, from inside the door, insert the interior assembly into the latch.
- Align the corresponding holes on the interior assembly with those on the latch.
- Fasten the interior assembly in place using the screws supplied.
For visual aids and comprehensive instructions, always consult the official EMTEK Single Cylinder Deadbolts Lock Installation Guide that came with your lock.
