Need help assembling and installing my Chief LSCU Designer Video Cart? Where do I start?

[MacPenelope]

Assembling and installing your Chief LSCU Designer Video Cart requires a few key steps to ensure safety and functionality. Here's a comprehensive guide:

1. Cart Assembly:

   • Unpack the cart: Remove all components and packaging, leaving the main assembly (N) in the box.
   • Position the assembly: Lift the main assembly (N) and carefully place it on the box's edge.
   • Attach couplers: Insert coupler assemblies (U) onto the main assembly (N), aligning the holes.
   • Secure couplers: Use M8 x 16mm flat head cap screws (V) to fasten the coupler assemblies (U) to the main assembly (N).
   • Install legs: Attach the four legs (P and Q) to the coupler assemblies (U) using M8 x 16mm flat head cap screws (V).
   • Remove from box: Carefully tip the cart onto its wheels and lock them.
   • Adjust height: Make any necessary height adjustments.
   • Insert endcaps: Place the endcaps (J) into each side of the main assembly (N).
   • Attach handles: Secure each side handle (K) to the main assembly (N) with M8 x 100mm socket head cap screws (W).

2. Display Installation:

   • Select hardware: Choose the correct screws, nesting spacers, and universal washers from the hardware bag to fit your screen.
   • Determine mounting holes: Identify the correct holes to mount your display to the cart.
   • Mount the display: Insert screws into the matching mounting holes and slide the locking plate (M) over one screw for stability.
   • Tighten screws: Ensure all screws are securely tightened.

3. Lever Lock Install:

   • Insert backplanes: Slide Lever Lock™ backplanes (T) into the slots on top of the faceplate assembly.
   • Secure backplanes: Make sure the Lever Lock™ backplanes (T) click into place and follow the manufacturer's instructions for attaching components.

4. Cable Management:

   • Route cables: Guide cables through the top and lower holes as needed.
   • Secure cables: Use cable covers to keep cables organized.

5. Covers Installation:

   • Place covers: Install the large cover (S) and small cover (R) by aligning them with their designated slots and pressing until flush.
   • Lock covers: Slide the handle to the locked position for each cover.

6. Adjustments:

   • Height adjustment: Follow the specific instructions provided in the Chief LSCU Designer Video Cart manual.
   • Tilt adjustment: Remove the display, adjust the tilt, and reinstall the tilt adjustment screws to your preferred angle.

Following these steps will help you successfully set up and use your Chief LSCU Designer Video Cart.