How to Install and Pair SUNRICHER SR-ZG2835RAC ZigBee Smart Dimmer?

[MacAnnie]

Setting up your SUNRICHER SR-ZG2835RAC ZigBee Smart Dimmer is straightforward with this guide. Here's how to install, pair, and troubleshoot it:

1. Installation:

   • Safety First: Before you start, always turn off the power at the circuit breaker.
   • Wiring: Follow the wiring diagram in the SUNRICHER manual. You'll find instructions for both 2-wire (no neutral) and 3-wire (with neutral) connections.
   • Compatibility Check: Ensure the load (e.g., your light bulbs) is compatible. Check your light's manual or ask the supplier.
   • Bypass Device: If using LED bulbs or energy-saving CFLs, consider using a Bypass device to prevent flickering, especially with low loads. The SUNRICHER manual should have more information on this.
   • Power On: Once the wiring is complete, turn the power back on.

2. Pairing with Your ZigBee Network:

   • ZigBee Hub: You'll need a ZigBee controller or hub (like Philips Hue, SmartThings, etc.).
   • Remove Existing Pairing: If the dimmer was previously connected, remove it from the network. See the SUNRICHER manual's "Factory Reset" section.
   • Add Device: In your ZigBee hub's app or interface, choose to add a new lighting device and put the hub into pairing mode.
   • Initiate Pairing: Follow your hub's specific instructions to start the pairing process.
   • Pairing Confirmation: The dimmer should connect to the network. You'll usually see an indicator in your hub's app.
   • Control: After successful pairing, you can control the dimmer via your ZigBee network.

3. Touch Link to a ZigBee Remote:

   • Initiate Touchlink Commissioning:
     • Method 1: Quickly press the "Reset" button on the dimmer four times (or cycle the power four times from the breaker) to start Touchlink commissioning. You have 180 seconds.
     • Method 2: Cycle the power. If the dimmer isn't on a network, Touchlink starts after 15 seconds (165-second window). If the dimmer is on a network, Touchlink starts immediately (180-second window).
   • Proximity: Bring your ZigBee remote or touch panel within 10cm of the dimmer.
   • Remote Pairing Mode: Put the remote or touch panel into Touchlink commissioning mode, following its instructions.
   • Confirmation: The remote should confirm linking (e.g., the light flashes twice).

4. Additional Functions & Troubleshooting:

   • Explore Features: The SUNRICHER manual also covers setting minimum brightness, startup brightness, find/bind mode, and using ZigBee Green Power remotes.
   • Get Help: For problems, check the manual's troubleshooting section or contact SUNRICHER customer support.

Important Note: This guide is based on general information. Always refer to the official SUNRICHER SR-ZG2835RAC manual for detailed and specific instructions.