How to Install and Operate a timberk TEC.E31X M 1000 Electric Convector?

[Iker]

Setting up your new timberk TEC.E31X M 1000 electric convector is straightforward. Here’s a detailed guide:

Installation:

Wall Mounting:

1. Unpack the convector and wall-mounting kit.
2. Select a wall location, ensuring sufficient clearance from furniture and the floor.
3. Mark the wall for drilling, noting the required height.
4. Drill holes, insert dowels, and attach the mounting brackets to the wall.
5. Securely hang the convector onto the brackets.

Foot Installation:

1. Turn the convector upside down.
2. Align the support feet with the holes at the bottom.
3. Insert the feet until they click into place.
4. Place the convector on a level surface.

Power Connection:

1. Verify the convector is compatible with a 220V~/50Hz single-phase power supply.
2. Ensure the voltage matches the device specifications.
3. Adhere to all electrical safety guidelines.
4. Plug the convector into a grounded outlet rated for at least 10A.
5. Keep the plug and socket dry to prevent electrical hazards.

Operation:

1. The control panel features a dual-button switch for power modes and a thermostat dial.
2. Use the buttons to choose between low or high heat settings.
3. Adjust the thermostat to your desired room temperature.
4. Turn off the convector by switching the buttons to the "0" position and unplugging it.

Maintenance:

1. Regularly wipe the exterior with a soft, damp cloth to remove dust.
2. Avoid abrasive cleaners or sharp objects.
3. Clean the rear of the convector periodically to maintain its efficiency.

By following these steps, you’ll be able to enjoy your timberk TEC.E31X M 1000’s efficient heating capabilities.