How to Install a WATERMARK MPU6 Soft Touch Lavatory Drain

[MaximusLee]

Installing your WATERMARK MPU6 Soft Touch Lavatory Drain properly ensures a leak-free and aesthetically pleasing finish. Here's a straightforward guide:

1. Disassembly:

   • Unscrew the tailpiece from the drain body.
   • Unscrew the nut and remove the washer and bottom gasket from the drain body.

2. Positioning in Sink:

   • From the top of the sink, insert the drain components into the sink opening.
   • If the cap has a Watermark logo, orient it as desired.

3. Reassembly:

   • Place the bottom gasket on top of the nylon washer.
   • Place the nylon washer on top of the nut.
   • Screw the nut back onto the drain body, but avoid over-tightening.

4. Securing the Tailpiece:

   • Apply Teflon tape to the threads on the tailpiece.
   • Screw the tailpiece back into the drain body.

5. Connection and Leak Check:

   • Connect the drain to the p-trap.
   • Carefully inspect for any leaks.

Important Installation Notes:

• Always use Teflon tape or pipe sealant for threaded connections to prevent leaks.
• Do not use plumber’s putty on brass components as it can cause tarnishing. Instead, a non-corrosive Alkoxy Silicone sealant is recommended.
• The warranty for WATERMARK drains covers mechanical failure only, not finish defects. For technical support or further assistance with your WATERMARK MPU6 Soft Touch Lavatory Drain, contact Watermark Designs directly at 718-257-2800.