How to configure the address for the PAD100-RM Relay Module?

[DelSamantha]

Configuring the address for your PAD100-RM Relay Module is straightforward. This process allows the module to communicate correctly with your fire alarm system's SLC loop. Here's how to set the address:

Step 1: Locate the Dip Switches: Find the dip switches on your PAD100-RM Relay Module. These switches control the module's address.

Step 2: Understand Address Settings: Each PAD device, including the PAD100-RM, requires a unique address. The PAD100-RM uses a seven-position dip switch for address configuration, supporting addresses from 1 to 127.

Step 3: Consult the Manual: Use the address setting table found in the PAD100-RM manual. This table will guide you on the correct dip switch positions for the desired address.

Step 4: Set the Address: Adjust the dip switches on the PAD100-RM according to the manual's instructions and the address you need.

Step 5: Verify System Configuration: Confirm that the address set on the PAD100-RM matches the address programmed in your fire alarm control panel or system. Ensuring this match is vital for proper operation of the fire alarm system. Consult the PAD100-RM manual for comprehensive instructions and troubleshooting steps. Setting the correct address is critical for the PAD100-RM to function effectively within your addressable fire system.