Assembling your Prevue Hendryx 58501 Ferret Stack One Story cage ensures a secure and comfortable home for your ferret. Here's a step-by-step guide to help you put it together correctly:
-
Attaching the Legs and Tray Channel Rails:
- Begin by orienting the front legs (F1) so the wind bell lock faces forward.
- Attach the extended portion of the tray channel rail (L1) to the inside of the frame legs using the provided hex screws through the bottom holes.
- Attach the back legs (B1), ensuring the tray channel backstop faces the rear, and secure them to the sides with hex screws in the bottom holes.
-
Installing the Shelf and Casters:
- Attach the shelf (CS) using hex screws near the base of the legs.
- Turn the assembled unit upside down and insert a caster into each leg.
- Flip it right-side up and place the floor grille (CG) in position.
-
Assembling the Side Panels and Roof:
- Position the side panel (L2) and the lower back panel (B2) and join them using hex screws at the top and bottom corners.
- Attach the right side (R2) and front (F2) panels similarly, using hex screws at the top and bottom corners.
- Place the roof panel (CR) in position and secure it with a hex screw on each end.
-
Final Assembly Steps:
- Use the hex key to tighten all screws until they are snug.
- Hook a ramp to the underside of the platform and place it in the cage on the middle horizontal wire.
- Add the hammock and rotate the wind bell lock up to slide the tray into the channels.
Following these steps will help you correctly assemble your Prevue Hendryx 58501 Ferret Stack One Story cage. If you face any challenges during assembly, don't hesitate to reach out to Prevue Pet Products customer support for assistance.
