To successfully connect your Altronix AL1002ADA220 NAC Power Extender to your Fire Alarm Control Panel (FACP), follow these steps: First, mount the unit by marking and pre-drilling holes in the wall, aligning with the enclosure's keyholes. Secure the enclosure with screws, and ensure proper grounding. Second, establish the wiring connections. Connect the line (L) and neutral (N) terminals to a dedicated, unswitched AC circuit for your fire alarm system. Before connecting any devices, measure the output voltage to prevent damage. Connect the battery to the terminals labeled [- BAT +] on the Power Supply Board using two 12VDC batteries in series. Third, configure output programming. Use the output selection switches marked [OUT1 through OUT4] to match the corresponding inputs [IN1 & IN2], selecting the desired output signal type as detailed in the Output Programming Selection Table within the manual. Fourth, connect to the FACP. Refer to the Application Guide to connect the FACP output to the appropriate logic board inputs and connect your notification appliances to the relevant logic board outputs. Finally, perform testing and maintenance. Conduct annual tests to verify correct operation, including output voltage, battery status, and fuse integrity. Replace fuses as necessary and monitor/replace batteries as needed. Following these steps and consulting the detailed Altronix AL1002ADA220 NAC Power Extender installation guide will ensure a reliable connection to your Fire Alarm Control Panel.
