To modify the user code on your Roger Technology H85/TDS Keypad Selector, follow these steps:
-
Storing a New User Code:
- Begin by entering the existing user code to enter the programming mode.
- Enter 0000. The red LR LED should illuminate.
- Input your new user code (for instance, 12345) followed by ##.
- A successful entry will be indicated by the green LV LED lighting up for 2 seconds and a corresponding buzzer sound.
-
Activating the New User Code:
- Enter the stored user code (e.g., 12345) followed by an asterisk (*).
- If the code is correctly stored, the green LV LED on the keypad will light up.
- Press and hold the enabled key or channel associated with the user code.
- For example, if you have channel B enabled, you would enter: 12345*B.
-
Deleting a User Code:
- Determine the user code you want to remove (e.g., 12345).
- Enter ##12345*.
- If successful, the red LR LED will blink and then stay on steadily.
-
Changing the Password:
- To change the password from the default (0000) to a new code, such as 12345:
- Enter **0000# (red LR LED lights up).
- Then, enter your new password (e.g., 12345) followed by ##.
-
Resetting to Factory Default Password:
- If you've forgotten your password, you can reset it to the factory default (0000) using a known user code:
- Enter **12345# (red LR LED lights up).
- Enter 0000# to reset the password.
Always consult the Roger Technology H85/TDS Keypad Selector manual for complete instructions and safety guidelines. If you run into issues, refer to the troubleshooting section in the manual for assistance.
