How do I turn on my ThinkWare Dash Cam after installing it?

[CodyAnn]

After installing your ThinkWare Dash Cam, powering it on is straightforward. Here's how to ensure it works correctly, depending on your vehicle type:

For vehicles with combustion engines:

1. With the vehicle's ignition off, connect the IGN-3F to the 10-Pin Molex connector on the HWK-TW01-HAR.
2. When you start the vehicle, the LED on the IGN-3F should change from flashing to solid, showing the dash cam is receiving power.

For vehicles with electric motors:

1. Find the nearest switched accessory power receptacle (cig plug) and connect the provided power receptacle "T" harness in-line with the factory harness and the receptacle.
2. Route the 10-pin Molex side of the “T” harness to the OBDII area and connect it to the mating 10-Pin Molex connector installed previously.
3. With the ignition off and the IGN-3F plugged in, the LED should flash slowly. The LED will turn solid when the vehicle is started.

Operation:

• The dash cam turns on automatically when the vehicle starts and stays on during start/stop sequences.
• It turns off about two and a half minutes after the vehicle is shut down.

If you need more help, contact Echomaster at [e-mail] or call [phone].