How do I sync the ThermoPro TP-60S remote sensor with the base station?

[EmmanuelMarie]

To sync your ThermoPro TP-60S remote sensor with the base station, follow these steps: First, place the remote sensor near the base station. Then, install batteries in the base station; the RF signal icon on the display will flash for three minutes, indicating sync mode. If the icon stops flashing before syncing, press and hold the CHANNEL/SYNC button on the base station for 3-4 seconds to re-enter sync mode. Next, install batteries in the remote sensor. You can also press the TX or RESET button inside the remote sensor's battery compartment. The temperature and humidity readings from the remote sensor should now appear on the base station, confirming successful syncing. To add more sensors, repeat these steps; up to three remote sensors can connect to one base station. To permanently display a specific sensor's readings, press the CHANNEL/SYNC button on the base station until a circular arrow appears under the channel number. This will stop the channel cycling and display the selected sensor's data. Note that the unit cycles through channels for the first three minutes during syncing. Afterwards, you can choose a specific channel or enable auto-scroll mode. For further details, consult the ThermoPro TP-60S Wireless Indoor/Outdoor Humidity and Temperature Monitor Instruction Manual.