How do I sync my ThermoPro TP65 remote sensor?

[EdwardFitz]

To sync the remote sensor with the base station for your ThermoPro TP65 Wireless Humidity and Temperature Monitor, follow these simple steps: First, place the remote sensor near the base station. Next, insert the batteries into the remote sensor. After the batteries are installed in the base station, the RF signal icon on the display will flash for approximately 3 minutes, showing it's in synchronization mode. If the RF signal icon stops flashing before the sync is complete, press and hold the CHANNEL/SYNC button on the base station for 3-4 seconds until the RF signal icon starts flashing again. Then, either wait a moment or press the TX or RESET button located inside the remote sensor's battery compartment. Finally, the temperature and humidity readings from the remote sensor will appear on the base station display, confirming successful synchronization. Remember, if you replace batteries or if the connection is lost between the base station and remote sensor, repeat this process to re-establish the link. You can register up to 3 remote sensors with a single base station by repeating these steps for each sensor.