How do I set up my PetSafe Stay & Play Compact Wireless Fence?

[Gretchen]

Setting up your PetSafe Stay & Play Compact Wireless Fence involves a few key steps to ensure your pet's safety and containment. Here's a step-by-step guide:

1. Setting Up the Transmitter:

   • Place the transmitter indoors, choosing a dry, well-ventilated location. Ensure it's protected and at least 2 feet above the floor, ideally on your home's ground floor.
   • Keep the transmitter at least 3 feet away from large metal objects that could interfere with the signal.
   • Plug the power adapter into a standard 120-volt outlet.

2. Charging the Receiver Collar:

   • Remove the receiver collar strap from the front of the unit.
   • Lift the rubber plug to access the receiver charge jack.
   • Connect the receiver charger to the charge jack. A red light indicates charging, which turns green when complete.

3. Preparing the Receiver Collar:

   • Use the contact point wrench to securely tighten the contact points on the collar.
   • Turn on the receiver by holding the mode button for 5 seconds. The indicator light will show the battery status for 5 seconds and then flash the static correction level settings.

4. Adjusting the Pet Area:

   • Decide on your desired pet area size.
   • Adjust the boundary switch and boundary control dial on the transmitter to match your chosen area.
   • Use the test light tool to verify the boundary zone's location.

5. Placing Boundary Flags:

   • With the receiver collar on and facing away from the transmitter, walk towards the boundary zone. The collar will beep when you reach the boundary.
   • Place a boundary flag at that location. Repeat around the perimeter, placing flags approximately every 10 feet.

6. Fitting the Receiver Collar:

   • Make sure the transmitter is unplugged and the receiver is off.
   • Place the collar on your pet, logo-side up. Center the contact points under your pet's neck, ensuring they touch the skin.
   • Check the fit; you should be able to insert one finger between the contact point and your pet's neck. Trim the collar if necessary.

7. Training Your Pet:

   • Follow the training instructions in the manual to teach your pet about the boundary.
   • Begin with the collar on the lowest level, tone-only, and gradually increase the static correction level as needed.
   • Use positive reinforcement and rewards during training sessions.

For more detailed information and troubleshooting, consult the complete PetSafe Stay & Play Compact Wireless Fence user manual.