How do I set up my Omnitronic ALP-5A Active Speaker Set of 2?

[McJoy]

Setting up your Omnitronic ALP-5A Active Speaker Set of 2 is straightforward. Here's a step-by-step guide:

1. Installation:

   • Position your speakers as desired or use the included brackets for wall mounting. Ensure they are securely fastened.
   • Make sure the cooling fins on the active speaker are not covered, as they are crucial for heat dissipation.

2. Connections:

   • Connect the passive speaker to the RIGHT SPEAKER terminal.
   • Pay close attention to polarity: connect positive (+) to positive (+) and negative (-) to negative (-).
   • Connect your audio source (like an MP3 player, mixer, or computer) to the RCA jacks or the 3.5 mm jack. For mono sound, use the RCA jack labeled L/MONO.

3. Powering Up:

   • Use the provided power cable to plug the mains jack into a standard 230 V/50 Hz power outlet.
   • The fuse holder is located beneath the power input. If the fuse blows, replace it with one of the same type only after disconnecting the speaker from the power source.

4. Operation:

   • Turn the speakers on using the power switch (ON) or activate the standby function with AUTO ON.
   • Adjust the volume using the VOLUME control, and fine-tune the sound with the tone controls.
   • Choose between mono or stereo operation with the selector switch. In mono mode, only the left audio channel will be reproduced.

By following these instructions, you'll be enjoying your Omnitronic ALP-5A Active Speaker Set of 2 in no time!