How do I set up my NZXT SIGNAL HD60 capture card for streaming and recording?

[VanRosalie]

Setting up your NZXT SIGNAL HD60 external capture card for streaming and recording is straightforward. Here's a step-by-step guide:

1. Power Down: Begin by turning off both your gaming PC (or the device you'll be capturing from) and your PC or laptop that will be running the streaming/recording software.
2. USB Connection: Use the provided USB cable to connect the NZXT SIGNAL HD60 to your computer. Plug the USB-C end into the capture card and the other end into a USB 3.2 (Gen 1) port on your computer. This ensures sufficient bandwidth for high-quality video.
3. HDMI Input Connection: Connect your gaming PC, console, or other video source to the "IN" port of the NZXT SIGNAL HD60 using an HDMI cable. This will carry the video signal from your source.
4. HDMI Passthrough (Optional): If you're using a console or a dual-PC setup, connect a second HDMI cable from the "OUT" port of the capture card to your monitor. This provides a zero-lag passthrough, allowing you to see your gameplay without delay.
5. Power On: Turn on your computer and the device you're capturing from.
6. Software Configuration: Open your preferred streaming or recording software (OBS Studio, Streamlabs, etc.). Add a new "Video Capture Device" source and select "NZXT Signal HD60" from the device list. Configure the resolution, frame rate, and other settings to match your desired output. You should now be capturing video from your device.

Following these steps will help you successfully set up your NZXT SIGNAL HD60 capture card. For detailed specifications and additional troubleshooting steps, consult the NZXT documentation or their support resources.