Setting up your Coleman SaluSpa Bahamas AirJet inflatable hot tub is straightforward. Here's a step-by-step guide:
- Choose Your Spot: Find a flat, level surface that can handle the weight of the filled hot tub and its users. Avoid placing it on carpet.
- Indoor Setup Considerations: If inside, ensure good ventilation to prevent humidity. Consider consulting a professional for additional ventilation if needed.
- Outdoor Setup Considerations: Locate the hot tub near a floor drain to handle potential water spills. Try to avoid direct sunlight for extended periods.
- GFCI Test: Before plugging in the hot tub, test the Ground Fault Circuit Interrupter (GFCI) by pressing the test button. The hot tub shouldn't operate. Then, reset the GFCI by pressing the reset button. The hot tub should then operate normally.
- Inflation: Use the included pump to inflate the hot tub. Make sure the inflation hose is clear and the air valves are sealed properly. Do not use an air compressor.
- Water Filling: Connect a garden hose to the water inlet valve and fill the hot tub. The water temperature should be above 42.8°F (6°C) to prevent the E03 error.
- Power On: Plug the pump into a grounded outlet. Press and hold the On/Off button on the control panel for 2 seconds to activate.
- Heating and Massage: Use the temperature buttons to set your desired water temperature. Press the Heat button to start heating and the Massage System button to activate the jets.
- Water Maintenance: Clean and replace the filter cartridges regularly to keep the water clean. Use appropriate pool chemicals to maintain water balance. Consult with your local pool supply store for specific guidance.
- Storage and Disassembly: When not in use, drain the hot tub completely and let it dry. Clean the spa and deflate it using the deflation function. Store it in a warm, dry place.
For more detailed information and safety instructions, please refer to the Coleman SaluSpa Bahamas Owner's Manual, which comes with the product.
