Setting up your Clearaudio Innovation Wood Turntable correctly is key to experiencing its exceptional sound quality. Here's a step-by-step guide to help you assemble and install your turntable. First, ensure you have a stable surface measuring at least 18.90 inches x 19.29 inches for the turntable. Place the three black flat pads provided on your hifi-rack or other suitable base. Position the Clearaudio Innovation Wood Turntable body on these pads, aligning the spikes. Next, ground the bearing by attaching the supplied grounding wire to the bearing cap. To prepare the bearing, remove the protective tape from the bearing housing and apply two drops of the synthetic bearing oil provided onto the ceramic bearing shaft. For platter assembly, mount the bearing part with the sub-platter using the mounting clip. Carefully place the stainless steel platter onto the bearing, and then secure the Delrin platter, ensuring the cut-out side faces up. Install your tonearm and cartridge, following the manufacturer's instructions. Use the Smart Level Gauge included to precisely adjust the cartridge's tracking force. Fine-tune the motor speed using the trimmers on the back of the turntable, and use the Clearaudio Stroboscope Testrecord for accurate calibration. Before powering up, check that the turntable is level using the bubble level gauge. Connect the power supply and carefully place the flat belt around the platter and motor pulley. Finally, start the turntable and allow it to run for 15 to 30 minutes to break in. Regularly check the speed accuracy and make any necessary adjustments. By following these steps, you'll be well on your way to enjoying the superb audio performance of your Clearaudio Innovation Wood Turntable. If you need further assistance, consult the troubleshooting section of the user manual or contact your dealer.
