Setting up and operating the Advanced Amplifiers AA-1M6G-30 Solid State RF Amplifier System requires careful attention to detail. Follow these steps for optimal performance:
-
Incoming Inspection: Before using the amplifier, inspect it for any external damage or missing components. Ensure all front and rear panel connectors are in good condition and that the fans and airways are clear of any obstructions.
-
RF & AC Cable Connections: Connect the RF input and output cables to the specified connectors as detailed in the product manual. Use the provided AC power cable or one with a comparable or higher power rating. Refer to the front and rear panel diagrams to locate the RF and AC power connectors.
-
RF Turn On Procedure:
a. Connect the RF input to an RF pulse generator and gating signal.
b. Attach a suitable load to the output connector.
c. Turn on the AC switch; the display should indicate "STANDBY."
d. Optionally, connect the unit to digital control software or via an Ethernet connection.
e. Set the RF generator to 0dBm and your desired frequency within the operational range.
f. Choose Gain or ALC and set the output power level, then press the ONLINE button.
g. Use the front panel controls or remote function to adjust the output power as needed.
-
RF Turn Off Procedure:
a. Reduce the RF drive from the generator to below -20dBm.
b. Press STANDBY on the LCD screen or through the control software.
c. Turn off the AC switch on the front panel.
d. Disconnect any unnecessary cable connections.
-
Safety Instructions:
a. Ensure proper grounding with a connection to an uninterrupted safety ground.
b. Always connect the RF output connector to a load before turning on the AC switch.
c. Turn off both AC and RF power before disconnecting the output load or other components.
d. Keep all air inlets and outlets clear to maintain optimal performance. Following these guidelines will ensure the safe and effective operation of your Advanced Amplifiers AA-1M6G-30 amplifier.
