Setting up your Anolis Ambiane HP111 Surface Mount fixture involves a few key steps. First, installation must be handled by a qualified electrician, adhering to all local and national electrical codes. Prepare a circular opening in your ceiling to accommodate the fixture. Secure the control unit above the ceiling, using the opening for access. Next, connect the terminal blocks. These include the supply cable, DMX cable, and the LED unit cable to the control unit. Also, install other required terminal blocks. For the connections, follow these guidelines: Primary and secondary power connections should be Vcc (Power +) and 0V (Power -). For DMX connections, use D+ (Data +), D- (Data -), and 0V (Data ground). If using 0-10V control, connect D+ (+10V) and 0V. Remember that DMX connectors are also used for 0-10V control. Now, let's look at the DIP switch settings: Use the trimmer to adjust the light intensity. The DIP switch selects the operation mode (DMX, DALI, or 0-10V). Setting DIP 10 to ON activates the test light. DIP 11 OFF indicates DMX 512 and DALI, while ON enables 0-10V control. For DMX addressing, configure the start address for receiving instructions from your DMX controller. You can set the DMX address using the DIP switch or RDM, with the green LED indicating the current method. For additional control methods, consider these options: For DALI control, address the fixture using an external DALI controller for persistent control. If using 0-10V control, set DIP 11 to ON. This will prioritize the 0-10V commands over DALI and DMX commands. The Anolis Ambiane HP111 supports RDM for bi-directional communication and software updates.
