Setting the time and date on your SMARTRO SC91 Projection Alarm Clock is straightforward. Here's a step-by-step guide:
- Power Up: First, plug the power adapter into your clock and connect it to a power source.
- Battery Prep: Remove the battery cover on the back of the clock and take out the battery insulation sheet. Replace the battery cover. Remember, the battery primarily maintains settings; it's not the primary power source.
- Sensor Setup: Open the battery compartment of the wireless remote sensor and insert 2 AA batteries, ensuring correct polarity (+ and -). Close the compartment.
- Sensor Connection: Allow up to 3 minutes for the clock to connect with the wireless remote sensor.
- Enter Setup Mode: Once connected, the clock enters normal mode. Press and hold the "SET" button for over 3 seconds.
- Time Format: The 12Hr/24Hr display will flash. Use the "+" and "-" buttons to select either a 12-hour or 24-hour time format and press "SET" to confirm.
- Set Hour: The Hour display will flash. Use the "+" and "-" buttons to set the correct hour and press "SET".
- Set Minute: The Minute display will flash. Use the "+" and "-" buttons to set the correct minute and press "SET".
- Set Year: The Year display will flash. Use the "+" and "-" buttons to set the correct year and press "SET".
- Set Month: The Month display will flash. Use the "+" and "-" buttons to set the correct month and press "SET".
- Set Date: The Date display will flash. Use the "+" and "-" buttons to set the correct date and press "SET".
- Date Display Format: The Month and Date icon display will flash. Use the "+" and "-" buttons to choose between Month/Date or Date/Month format and press "SET".
- Weekday Language: The language selection for the weekday display will flash. Use the "+" and "-" buttons to select your preferred language and press "SET".
- Weather Forecast: The weather forecast pattern display will flash. Use the "+" and "-" buttons to select the current weather pattern and press "SET" to finish the setup.
Note: The clock will automatically exit the setup mode if no button is pressed for 30 seconds.