To safely and correctly use the TSI VIPER VP18AL 18 Liter Viper Tire Bead Seater, follow these steps:
- Prepare the Wheel: Start by thoroughly cleaning the wheel rims. Make sure to lubricate both the tire beads and the rim flanges using a tire lubricant that is approved. Remove the valve stem core from the wheel.
- Connect the Air Line: Attach an air line to the valve stem using a quick-disconnect fitting (not included). You can also use the optional whip hose, part number 01.109, if you have one. If needed, thread the air line or whip hose through the rim center.
- Position the Wheel: Place the wheel on a tire stand, ensuring the lower tire bead rests securely on the wheel bead-seat area. Proper alignment is important to capture the air blast effectively within the tire cavity.
- Seat the Tire Bead: Open the whip hose to permit air to flow through the valve stem. Hold the Viper™ tank firmly, using one hand on the forward handle and the other on the rear. Position the Viper™ at approximately a 35-45 degree angle, keeping it away from the tire. Press the trigger to discharge the tank.
- Adjust Air Pressure: It's not always necessary to fill the tank to its maximum pressure. Begin with a lower pressure and gradually increase it to find the ideal setting for your specific tire. Most tires can be seated between 80 PSI and 100 PSI.
- Complete the Process: Once the bead fully moves into position, shut the whip hose valve. Detach the whip hose locking chuck from the valve stem and reinstall the valve stem core. Make sure the valve stem core is securely tightened.
- Check for Leaks: After seating the bead, carefully check for any leaks. If any are found, address them and repeat the process if necessary. If no leaks are present, put the valve cap on the valve stem and remove any excess lubricant. Following these steps and heeding all safety advice found in the manual will ensure you can use your TSI VIPER VP18AL 18 Liter Tire Bead Seater safely and effectively.
