To ensure a strong and lasting bond when mounting your Q-TRAN LALO Linear Fixture using the VHB adhesive method, careful surface preparation is key. Here's a detailed guide: First, maintain an ideal application environment between 70-100ºF with 50% humidity or less. The minimum application temperature should be 50ºF, and it's crucial to maintain these conditions for 72 hours after application for optimal bond strength. Begin by cleaning both the back of the fixture and the mounting surface with a 50/50 alcohol mix. Allow the surfaces to dry for approximately 5 minutes. Next, apply the VHB tape: Peel back about 0.5 inches of the protective film from one end of the tape and firmly press it onto the surface, avoiding any air bubbles. Continue peeling and adhering the tape in small sections until the entire length is securely installed. For porous materials like wood, brick, or concrete, apply two coats of paint or primer to the surface before installing the fixture. This improves adhesion. Consider these epoxy recommendations based on your surface material: For Concrete, Stone, Cinderblock, Metal, and Brick, use Loctite Metal and Concrete Two-Part Epoxy. For ABS, Fiberglass, Plastic, and PVC, opt for Loctite Plastic Two-Part Epoxy. If working with Tile, Wood, Ceramic, Glass, or Metal, choose Loctite Clear Two-Part Epoxy. Alternatively, Strong Stik can be used as an all-purpose epoxy. Following these steps will help you achieve a successful and durable installation of your Q-TRAN LALO Linear Fixture.
