Installing ClarkDietrich BS-10 Big Stick Composite Corner Bead correctly involves precise cutting and careful application. Here's a step-by-step guide:
Cutting the Big-Stick:
- Measure the wall height and subtract 1/2 inch.
- Use scissors or a utility knife to cut the Big-Stick to the measured length.
- Cut the ends of the Big-Stick at a 45-degree angle to ensure a flush fit at the corners.
Installing the Big-Stick:
- Apply a generous, smooth layer of all-purpose compound to the corner using a 4-inch or 5-inch taping knife.
- Press the Big-Stick firmly into the wet compound, adjusting until it aligns perfectly straight.
- Wipe down the Big-Stick tightly with the taping knife, applying extra pressure on the outer edges for a secure bond.
- Immediately apply a thin skim coat of compound over the surface, wiping it down smoothly.
- Allow the compound to dry completely for several hours or overnight, as specified by the compound's instructions.
Final Coating:
- Apply a final coat of compound using a 6-inch or 8-inch taping knife, feathering the edges beyond the previous coat for a seamless transition.
- Allow this final coat to dry completely for the recommended time.
Finishing Touches:
- Lightly sand the surface with 120-grit sandpaper for a smooth finish. The composite material of the Big-Stick won't fuzz up like paper or mesh tapes, offering a cleaner result.
Following these steps will help you achieve a professional finish when installing ClarkDietrich BS-10 Big Stick Composite Corner Bead.
