How do I program my Automatic Technology FHCRX-1 Multi-Frequency Receiver for my garage door?

[HopeLynn]

Programming your Automatic Technology FHCRX-1 Multi-Frequency Receiver for your garage door involves a few straightforward steps. Here's a guide:

1. Setting the Transmitter Type: The first step is to configure the receiver to recognize your transmitter type (ATA TrioCodeTM or BND Tri-TranTM). This is determined by the first memory location programmed.

2. Storing Transmitter Codes:

   • Locate and press and hold either SW1 (for Relay 1) or SW2 (for Relay 2) on the receiver board. The LED indicator will begin to flash.
   • Press the button on your transmitter that you wish to use for your garage door for about two seconds.
   • The LED on the receiver will flash more rapidly. Release the transmitter button.
   • Pause for two seconds and then press the same transmitter button again for two seconds.
   • The LED will then stay on for a second, and then turn off, confirming the code has been stored.
   • Release the SW1 or SW2 button.
   • Test the operation by pressing the transmitter button to ensure it functions correctly.

3. Deleting a Single Transmitter Code:

   • Press and hold SW1 or SW2 on the receiver board; the LED will start flashing.
   • Press the transmitter button that you want to remove from the receiver's memory for about two seconds. The LED will flash faster.
   • Release the transmitter button, pause for two seconds, then press the same button again for two seconds.
   • The LED will then slowly flash twice, indicating the code has been deleted.
   • Release the SW button.
   • Test the transmitter button to verify the code has been removed and that it no longer operates the garage door.

4. Deleting All Stored Transmitter Codes:

   • Turn off the power to the FHCRX-1 receiver.
   • Press and hold the SW1 button.
   • While keeping SW1 pressed, turn the power back on. After about 15 seconds, the Coding LED will illuminate, indicating that the receiver's memory has been cleared.
   • Release SW1.
   • To confirm, try pressing the transmitters that were previously used to operate the device; they should no longer function, verifying the codes have been deleted.

By following these steps, you should be able to successfully program your FHCRX-1 Multi-Frequency Receiver for use with your garage door opener.