Installing the Signature Hardware 941510 Shockoe Single Light 14 Inch Tall LED Outdoor Wall Sconce correctly involves several steps. First, prioritize safety by turning off the power at the circuit breaker and removing the old fixture, including its crossbar. Next, unpack your new Signature Hardware sconce and carefully lay out all components in a clear space to avoid losing any small parts. Assemble the mounting plate by threading the two mounting screws to it, adjusting their length if necessary. Attach the mounting plate to the outlet box using the outlet box screws. When it comes to electrical wiring, connect the black wire from the fixture to the black (hot) house wire, and the white wire from the fixture to the white (neutral) house wire. Secure all wire connections with wire nuts, and consider wrapping them with electrical tape. If your outlet has a ground wire, connect the fixture’s ground wire to it; otherwise, connect the fixture’s ground wire directly to the mounting plate. Neatly tuck the wire connections into the junction box. Now, attach the fixture to the mounting plate using the mounting screws and secure them with the cap nuts. To prevent moisture, apply clear caulk around the outside of the fixture’s backplate where it meets the wall, leaving a small space at the bottom for moisture to escape. Finally, before restoring power, double-check all connections to ensure everything is secure. For further guidance, consult the Signature Hardware 941510 Shockoe manual, or contact Signature Hardware Customer Service.
