How do I install the Siemens NET-4 Communication Interface Module in my PSR-1 remote power supply?

[LeGideon]

To install the Siemens NET-4 Communication Interface Module into your PSR-1 remote power supply, please follow these steps: First, carefully remove the NET-4 from its antistatic bag, avoiding contact with the gold-plated card edge. Next, mount the two provided card guides on the right side of the PSR-1, positioning them above and below connector P7. If screws are already present where the card guides attach, remove them and use the provided hardware to secure the guides. Then, slide the slot at the base of each card guide under a mounting screw and tighten it. After this, insert the NET-4 into the card edge connector P7 on the PSR-1, ensuring the components face the right side of the PSR-1. For details on connecting to the MXL network, consult the PSR-1 Installation Instructions (P/N 315-090911). Finally, always verify that all terminals are power-limited to prevent electrical problems. Following these steps will help you successfully install your Siemens NET-4 Communication Interface Module.