Installing the Moultrie Ranch Series Auger Feeder Kit involves a few straightforward steps. First, assemble the auger feeder kit. Begin by removing all parts from the packaging. Attach the M6 bolts with washers through the mounting holes on the bottom of the feeder hopper. Then, remove the rubber grommet from the hopper cone. Locate and remove the access door on the right side of the auger kit. Carefully lift the auger kit up to the hopper, aligning the mounting hardware with the three holes on top of the auger kit. Secure the auger kit using flat washers and hex nuts for each bolt. Reattach the access door, ensuring it is securely fastened. Next, install the feed chute and battery. Position the feed chute mounting flanges over the square outlet on the bottom of the auger kit and secure them with bolts and nuts. Adjust the feed chute angle as needed and tighten the bolts to hold it in place. Connect a Moultrie 12V 7ah Rechargeable Battery, attaching the red cable to the positive terminal and the black cable to the negative terminal. Place the battery inside the compartment, making sure the terminals don't touch the sides of the auger kit. Finally, configure and test your feeder. Use the programming buttons to set the current time, day, estimated feed remaining, feed times, days of the week, run duration, and motor speed. Test the system by entering Test Mode and setting the duration and motor speed. Close and secure the main door of the auger kit. Following these steps, along with the detailed instructions in the Moultrie Ranch Series Auger Feeder Kit manual, will ensure your feeder is set up correctly for optimal performance.
