Installing the LITHONIA LIGHTING OFL2 LED IS LED Flood Luminaire safely and correctly requires attention to detail. Before you begin, always disconnect or turn off the power supply to the circuit. Make sure the supply voltage matches the luminaire's specifications. Always wear appropriate safety gear, including gloves and safety glasses. Avoid direct eye exposure to the light source. Keep flammable materials away from the fixture. For the OFL2 IS (Integral Slip Fitter Mounting) model, you'll need a 1/4” and 3/16” hex socket driver and a flat head screwdriver. Secure the slip fitter to the tenon and make the electrical connections inside the wiring compartment. Adjust the tilt angle as needed by loosening and tightening the screws. If you have the OFL1&2 YK (Yoke Mounting) model, you'll need a hex socket driver and a regular screwdriver. Adjust the tilt angle by loosening the hex bolts, positioning the fixture, and then re-tightening the bolts. Mount the fixture to your chosen bracket using the provided hole pattern. Optional accessories include a Vandalguard, which replaces the glass lens (unscrew the socket head screws on the bezel), and a Wireguard (insert the guard and re-install the bezel). For wiring, ground the fixture by connecting the house supply ground wire to the fixture ground wire with a wire nut. Use wire nuts to properly connect the supply wires. If the fixture doesn't work, first check that the power is on at the switch and breaker, and that the wiring is correct. If problems persist, contact technical support. Clean the luminaire surfaces with mild soap and water when the fixture is cool; avoid abrasive materials and touching the LEDs. Driver access is available by unscrewing the socket head screws in the back of the housing. Refer to the LITHONIA LIGHTING OFL2 LED IS LED Flood Luminaire's instruction manual for detailed diagrams and safety information.
