Installing the KUFATEC VW T5 7H Complete Active Sound system with Soundbooster requires careful attention to detail. Here's a general overview of the connection process. Always consult the official KUFATEC manual for your specific model for detailed, step-by-step instructions. To connect the cables: First, locate the vehicle's cable you'll be connecting to (usually marked green) and use a suitable tool to strip a small section of its insulation. Next, strip the insulation from the corresponding KUFATEC cable (usually marked yellow). Twist the exposed wires of both cables together. Place the stripped end of the KUFATEC cable against the stripped point on the vehicle's cable, wrapping the KUFATEC wire around it. Secure the connection firmly with insulating tape. If the KUFATEC cable set has grey wires, connect them according to the cable inscriptions. Remember, this is a simplified guide. The complete installation involves removing trim panels, connecting CAN-High & CAN-Low wires, grounding the system, routing the connecting cable for the sound generator, and mounting the sound generator itself. The KUFATEC manual provides detailed guidance for all these steps. Always prioritize safety and be aware of any legal requirements for sound booster use in your area. If you encounter any difficulties during the installation, KUFATEC offers support via phone and email. They also provide installation services at their Bad Segeberg location, though costs incurred from third-party installations are not covered by KUFATEC unless due to a product defect.
