How do I install the KONDATOR 935-PM50 power socket into a table?

[OwenAnn]

Installing your KONDATOR 935-PM50 built-in power socket is straightforward. Here's how, based on the provided installation guide:

For a round hole:

1. DRILL: Start by drilling a hole in your table where you want the socket.
2. INSERT: Place the Powerdot into the hole, feeding the power cable through the table and the plastic fastening nut.
3. TURN & PLUG: Tighten the plastic fastening nut clockwise as much as possible to secure the socket. Then, plug the Schuko plug into a wall outlet.

For a tailored (milled) hole:

1. MILL: Create a hole in the table following the specifications for the KONDATOR 935-PM50.
2. INSERT: Insert the Powerdot into the tailored hole, guiding the power cable and the plastic fastening nut through the table.
3. TURN & PLUG: Tighten the plastic fastening nut until it's firmly in place. Finally, connect the Schuko plug to a power outlet.

Important points:

• Your KONDATOR 935-PM50 comes with one Schuko socket and a 1250 mm cable for easy installation.
• If you need more help, contact Kondator AB at Energivägen 8 - Box 121, SE-135 23 TYRESÖ, SWEDEN, or visit www.kondator.se.