How do I install the JVA ST113 Large Solar Kit?

[GrahamMarie]

Installing your JVA ST113 Large Solar Kit is straightforward. Begin by unpacking the kit and finding the U-Bolts. Attach the U-Bolts to the top and bottom panel of the bracket using the washers, spring washers, and hex nuts. Next, mark on your mounting pole where the top U-bolt will sit. Slide the U-bolts over the pole and tighten them at the mark. Slightly loosen the six bolts inside the frame, but don't remove them. Lift the bottom of the Solar Panel arms to a 90-degree angle, then tighten all six bolts and face the panel north. If you have a JVA Energiser, use the provided mounting screws to install it between the solar panel and the pole. Plug the JVA energiser into the solar panel lead; the energizer's alligator leads and plug pack will not be used. Finally, connect the red and black ring terminals to the battery. Alternatively, you can connect the energizer directly to the battery using the alligator leads provided. For information about choosing a suitable battery, consult the JVA website.