Installing the HINKLEY 17469 Beacon Hill 30-inch tall heritage outdoor wall fixture involves several key steps. First, prepare your workspace by unpacking the fixture and its glass components. Remove the mounting plate (A) from the backplate by unscrewing the side screws (S). Next, attach the mounting plate to your outdoor junction box using 8-32 screws (not included); adjust its position as needed. Secure the fixture by hooking it onto the installed mounting plate using the inspection cable (0) on the backplate. Carefully connect the wiring, following the instructions in the IS-18 sheet. Then, align the backplate over the mounting plate, securing it with the screws (S) you removed earlier. If extra support is necessary, use the holes (E) on the mounting plate with appropriate wall anchors. Always prioritize safety: read the wiring and grounding instructions in I.S. 18 and turn off the power. If new wiring is needed, consult a qualified electrician. To install the glass panels, begin by removing the bottom panel (2) from the cage assembly (4) by unscrewing the four corner screws (1). Slide out the existing glass panel, insert the new panel into the cage channels, and reattach the bottom panel. For weatherproofing, apply waterproof caulk or silicone sealant to the gap between the fixture's backplate and the wall, as well as the gap between the mounting top and the fixture base, including a small bead under the ball knobs. Following these steps ensures a successful installation of your HINKLEY Beacon Hill outdoor wall fixture.
