Installing your ECHOMASTER 19433433 ThinkWare DashCam involves several steps. Here's a helpful guide:
Tools You'll Need:
- 7mm, 8mm, and 10mm Nut Driver or Socket with Ratchet
- Plastic dash panel removal tool
- Drill with Phillips bit
- Alcohol Pads
What's in the Box?
- OBD II Plug-n-Play Thinkware Harness
- Forward-Facing Camera
- Rear-Facing Camera
- Connection Cable (front to rear camera)
- IGN-3F Ignition Module
- Windshield Mount (for front-facing camera)
- Micro SD Memory Card with Adapter
- Wire Ties, Self-Tapping Screws
Installation Steps:
- OBD II Connection: Find and disconnect the OBD II connector in your vehicle. Then, plug the Plug-n-Play harness into your vehicle's OBD II connector.
- Secure the Harness: Use wire ties and screws to secure the harness and connector.
- Power Cable Routing: Run the power cable to the driver's side of your vehicle.
- Front Camera Mounting: Clean the windshield area where you plan to mount the camera. Attach the front-facing camera using the provided mount.
- Cable Management: Neatly bundle and secure any extra cables.
Additional Steps (for certain vehicles):
- IGN-3F Module: Connect the IGN-3F module to the 10-Pin Molex connector.
- Electric Vehicles: If you have an electric motor, connect the power receptacle "T" harness in line with the factory harness. Ensure the LED on the IGN-3F module is working correctly.
Optional Rear Camera Installation:
- Cable Routing: Run the cable from the front camera to where you'll mount the rear camera.
- Rear Camera Mounting: Clean the mounting spot on the rear window and attach the rear-facing camera.
- Camera Position Check: Use the Thinkware smartphone app to confirm the camera's position.
Finishing Up:
- Secure Modules: Secure the module and OBD II junction under the dashboard.
- Reinstall Trim: Put back any vehicle trim you removed earlier.
