Installing Concept BikeErg Toe Clips One Pair is straightforward. Here's a step-by-step guide to help you get started:
- Gather Your Tools: You'll need a 5/16 inch (8 mm) wrench and a flathead screwdriver. Make sure you have these ready, as they're not included with the toe clips.
- Position Your Bike: Place your bike in a stable position. A bike stand is ideal, but you can also prop the rear wheel up if needed.
- Identify the Pedal: Decide which pedal you want to equip with a toe clip. Remember that each clip is designed for either the left or right pedal, so make sure you're using the correct one.
- Remove the Reflector (If Applicable): If your pedal has a reflector, you may need to remove it before installing the toe clip. Use the flathead screwdriver to carefully pry it off.
- Align the Toe Clip: Position the toe clip on the pedal. The curved part of the clip should face toward the front of the bike.
- Insert and Tighten Screws: Insert the provided screws into the holes on the pedal. Use the 5/16 inch wrench to tighten the screws securely. Ensure the toe clip is firmly attached.
- Repeat (If Necessary): If you're installing toe clips on both pedals, repeat steps 3-6 for the other pedal.
- Test the Installation: Once installed, give the toe clips a firm tug to make sure they're secure. Adjust or tighten the screws further if needed.
That's it! You've successfully installed your Concept BikeErg Toe Clips One Pair. Before each ride, double-check that the screws are tight to ensure the clips remain secure. For additional assistance or any other inquiries, contact Concept2 directly at 800.245.5676 or info@concept2.com.
